A high voltage chip resistor lets a UK EV charger measure its DC output and insulation without a bulky leaded part. With 124,738 UK chargers counted, Walsin lists 8,272 high voltage chip resistors at 1 percent and 100 ppm, 0603 to 2512, that cross Stackpole RVC sizes. Venatech is the authorised Walsin distributor in Hong Kong.
Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for power electronics engineers and buyers at UK makers of wallboxes, DC rapid and ultra-rapid chargers and charger power modules. Walsin Technology (Walsin) is the line we are authorised for; Stackpole Electronics (SEI) is a line we supply, so an RVC part already on your parts list can be quoted as it is or crossed to Walsin. We measured every Walsin figure below on 16 November 2026 in our Walsin high voltage chip resistor exports, the Thick_Film_High_Voltage_Chip_Resistor_*.xlsx files, and checked our ready stock snapshot dated 9 November 2026. Stackpole figures come only from Stackpole’s RVC press release on seielect.com, fetched the same day; the RVC datasheet itself did not load for us that day, so confirm each Stackpole figure against it.
How many EV chargers does the UK have at the end of September 2026?
124,738. EV Infrastructure News reported on 8 October 2026 that Zapmap counted 124,738 EV chargers in the UK across 48,298 locations, with 8,686 added in the first three quarters of 2026, 9 percent more than a year earlier.
The growth is at the high-power end. The same report counted 15,335 ultra-rapid chargers at 150 kW or more, up 39.1 percent year on year, and 1,070 charging hubs. Those are Zapmap’s figures, not ours. Every ultra-rapid unit carries DC bus and output voltage sensing, an insulation monitor and pre-charge control, and UK charger and power-module makers build those boards in volume. Our high voltage chip resistors and the limit nobody checks note explains why working voltage, not power, usually sets the part.
Where does a high voltage chip resistor sit in an EV charger?
In every divider that reads a high-voltage node. A DC charger reads its output and DC bus voltage, often up to about 1,000 V, through a string of high voltage chip resistors feeding a low-voltage ADC, and its insulation monitor uses similar strings from each DC rail to protective earth.
Pre-charge sensing, PFC bus monitoring and the bleed path that discharges the DC link after shutdown use the same parts. On an AC wallbox the job is smaller, but mains sensing and residual-current electronics still need parts with a stated working voltage. A standard chip resistor can be within its power rating and still be over its voltage rating, which is the failure a high voltage family is made to prevent. Leakage paths across the board matter as much as the part, so creepage on the layout belongs in the same review.
How many Walsin high voltage chip resistors are 1 percent and 100 ppm?
8,272. We filtered Walsin’s high voltage thick film chip resistor series, general and automotive, to 1 percent and 100 ppm and counted 8,272 distinct part numbers in five sizes from 0603 to 2512, from 47 ohm to 10 megohm; 2,618 of them carry the automotive tag.
| Size | Walsin parts at 1 percent, 100 ppm | Rated power (export) | Example at 1 megohm |
|---|---|---|---|
| 0603 | 1,599 | 1/10 W | WK06V1004FTL |
| 0805 | 1,751 | 1/8 W | WK08V1004FTL |
| 1206 | 1,751 | 1/4 W | WK12V1004FTL |
| 2010 | 1,590 | 1/2 W | WK20V1004FTL |
| 2512 | 1,581 | 1 W | WK25V1004FTL |
The automotive version of each 1 megohm part adds a J, for example WK25V1004FTLJ. Walsin’s high voltage series in our export also includes 0.5 percent and 2 percent parts, useful where a divider ratio must be tighter. We have not seen this 1 percent, 100 ppm cut counted by size elsewhere. Our export has no working-voltage column, so take the per-size voltage from Walsin’s datasheet.
Which Walsin parts cross a Stackpole RVC resistor?
From 0603 up, on size, tolerance and TCR. Stackpole’s press release of 20 September 2011 describes RVC as a medium voltage chip resistor rated from 100 V in 0402 to 3 kV in 2512, at 1 percent and 5 percent and TCR as low as 100 ppm, for high-voltage power supplies, instrumentation and motion controls.
| Your brief (RVC style) | Walsin part | Walsin size, power, TCR (export) | Match / mismatch | Your incumbent |
|---|---|---|---|---|
| 0402, 1 percent | none in the high voltage series | sizes start at 0603 | Mismatch on size: move to 0603 or keep the Stackpole part | |
| 0603, 1 megohm, 1 percent, 100 ppm | WK06V1004FTL |
0603, 1/10 W, 100 ppm | Match on size, value, tolerance, TCR | |
| 1206, 1 megohm, 1 percent, 100 ppm | WK12V1004FTL |
1206, 1/4 W, 100 ppm | Match on size, value, tolerance, TCR | |
| 2010, 1 megohm, 1 percent, 100 ppm | WK20V1004FTL |
2010, 1/2 W, 100 ppm | Match on size, value, tolerance, TCR | |
| 2512, 1 megohm, 1 percent, rated to 3 kV on RVC | WK25V1004FTL |
2512, 1 W, 100 ppm | Match on size, value, tolerance, TCR; working voltage: check Walsin’s datasheet against the 3 kV figure |
How do you size a 1,000 V divider string for a UK DC charger?
Voltage per part first, then power. Four 1 megohm resistors in series across 1,000 V carry 0.25 mA, so each drops 250 V and dissipates about 62.5 mW: the 1/4 W rating of a 1206 is not the limit, the per-part working voltage is.
Choose the number of parts so each sits well under its rated working voltage, with margin for surge and for the highest bus voltage your charger allows. Then check TCR tracking: if the top and bottom of the divider are the same family, their drift largely cancels; mixing families breaks that. Insulation monitors also care about leakage and humidity, so keep the string away from board edges and follow your creepage rules. For anything on a safety function, follow your own standards; we give no certification or compliance advice, so confirm with your compliance team. Our chip resistor power rating by case size note lists the power side by size.
How Venatech helps
Cross the whole sensing board in one paste. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating size, value, tolerance, TCR and power as match or mismatch.
Paste your divider and bleed lines into the cross-reference tool, or upload the parts list at BOM upload. We checked our ready stock snapshot dated 9 November 2026: the high voltage parts above are not on it, so request a quote and we source them through our authorised Walsin channel. Stackpole RVC lines can be quoted too; Stackpole is a line we supply, and Walsin is the line we are authorised for. We serve UK buyers from Hong Kong in small lots, and confirm availability, date code and lead time on each quote, with no price, lead-time or stock guarantee. The chip resistor range lists every Walsin family.
The short version
- Zapmap counted 124,738 UK EV chargers and 15,335 ultra-rapid units at the end of September 2026, per EV Infrastructure News on 8 October 2026.
- Walsin lists 8,272 high voltage chip resistors at 1 percent and 100 ppm from 0603 to 2512; 2,618 are automotive.
- Every RVC size from 0603 to 2512 has a Walsin match on size, tolerance and TCR; 0402 is the size to move or keep.
- In a 1,000 V divider, working voltage per part sets the count, not power.
Send us the divider and insulation-monitor lines from your charger, and we will return the Walsin crosses with every difference stated. How many parts does your output divider string use today?
Related reading
- High voltage chip resistors and the limit nobody checks
- Chip resistor power rating by case size
- When not to cross: cases where you keep the original
- Cross-reference tool, BOM upload and ready stock snapshot
Last reviewed: 16 November 2026.
Sources
Fetched 16 November 2026.
- EV Infrastructure News, “Zapmap: UK installed 8,686 new EV chargers through Q1-Q3 2026”, 8 October 2026: https://www.evinfrastructurenews.com/ev-fleet-charging/zapmap-uk-installed-8-686-new-ev-chargers-through-q1-q3-2026
- Stackpole Electronics press release on RVC medium voltage chip resistors, 20 September 2011: https://seielect.com/news/SE343_RVC_Series_092011.pdf
- Venatech Walsin high voltage chip resistor exports (Thick_Film_High_Voltage_Chip_Resistor_*.xlsx) and ready stock snapshot dated 9 November 2026, re-measured 16 November 2026.
Frequently asked questions
What does a high voltage chip resistor do in a UK EV charger?
It forms the dividers that read the DC output and bus voltage, the insulation monitor’s paths to earth, and the bleed path that discharges the DC link. Its job is to hold a stated working voltage that a standard chip resistor cannot.
How many Walsin high voltage chip resistors are 1 percent and 100 ppm?
8,272 in our export, in 0603, 0805, 1206, 2010 and 2512, from 47 ohm to 10 megohm; 2,618 of them carry the automotive tag.
Which Walsin part crosses a 2512 Stackpole RVC at 1 megohm?
WK25V1004FTL, a 2512, 1 megohm, 1 percent, 100 ppm, 1 W part in our export, or WK25V1004FTLJ for the automotive version. Compare working voltage on both datasheets before you approve it.
Is there a Walsin high voltage chip resistor in 0402?
Not in the high voltage series in our export, which starts at 0603. Move the position to 0603, or keep the Stackpole 0402 part, which we can quote.
Do you hold high voltage chip resistors in stock in Hong Kong?
Not on our ready stock snapshot dated 9 November 2026. Request a quote and we source them through our authorised Walsin channel, from Hong Kong in small lots, with no lead-time promise.
Is Venatech authorised for Stackpole?
No. Venatech is the authorised Walsin distributor in Hong Kong; Stackpole is a line we supply, and we quote Stackpole RVC lines alongside the Walsin cross.