NEWS

Cell Balancing Resistor for Karawang, Indonesia EV Battery Packs: 36 AEC-Q200 Walsin 47-Ohm Parts from 1/8 W to 3 W

A cell balancing resistor bleeds charge from the highest cells in a series string so a BMS can bring every cell to the same voltage. At 47 ohm, Walsin lists 36 high-power chip resistors tagged AEC-Q200, from 1/8 W in 0603 to 3 W in 2512. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for BMS and battery pack engineers and buyers in Karawang, the neighbouring Bekasi estates and across West Java. Walsin Technology (Walsin) is the line we are authorised for. We parsed our 79 chip resistor upload files, Venatech_ChipR_Upload_01.xlsx to Venatech_ChipR_Upload_79.xlsx, on 17 November 2026 and counted distinct part numbers in Walsin’s high-power families, separating the automotive series, tagged AEC-Q200, from the commercial and anti-sulfuration ones. We read the values against Walsin’s datasheets ASC_WFxxP_J_AUTO.pdf, ASC_WFxxA_J_AUTO.pdf and ASC_MFxxP_AUTO.pdf. Every part number below is real.

What is CATL and IBC’s battery plant in Karawang making?

Lithium-ion cells, with a pack line beside them. The Indonesian Mining Association reported on 15 September 2026 that PT Contemporary Amperex Technology Indonesia Battery, owned 70 percent by a CATL subsidiary and 30 percent by Indonesia Battery Corporation, began operating in Karawang in July 2026 with a first phase of 6.9 GWh, rising to at least 15 GWh.

The same report puts the full plan at about 1.2 billion US dollars, at Artha Industrial Hill and Karawang New Industry City. Investortrust, reporting officials’ confirmation on 21 August 2026, describes phased commercial operation under way and cells intended for passenger-car, two-wheeler and energy storage packs. Those are the publications’ figures, not ours. For a pack or BMS designer in West Java the consequence is direct: cells made in Karawang will be built into packs nearby, and every pack carries a balancing circuit.

What does a cell balancing resistor do in an EV or two-wheeler pack?

It burns off a small, controlled current from any cell that is ahead of the others. In passive balancing, the BMS switches a resistor across the high cell; at 4.2 V through 47 ohm that is about 89 mA and about 0.38 W, turned to heat in a part that sits on a crowded board next to the cells.

The value sets the balancing current and so how fast a pack can be equalised: a lower value balances faster and runs hotter. Pack makers choose between a few tens and a few hundreds of ohms depending on cell capacity, how much imbalance they expect and how much heat the board can shed. Because the resistor is switched on for long periods, often near the end of every charge, the rating that matters is steady power after derating, not a pulse rating. Our post on what AEC-Q200 actually certifies explains what the automotive tag covers.

How many AEC-Q200 high-power resistors does Walsin list at 47 ohm?

  1. We counted 14,954 distinct parts in Walsin’s automotive high-power thick film series, all tagged AEC-Q200, about 2,490 in each of six sizes; at 47 ohm there are 36, six per size, with two power grades in every case.
47 Ω, automotive high power, tagged AEC-Q200 Base power Upgraded power Parts
0603 1/8 W 1/3 W 6
0805 1/4 W 1/2 W 6
1206 1/2 W 3/4 W 6
1210 1/2 W 3/4 W 6
2010 1 W 1.5 W 6
2512 2 W 3 W 6
Total 36

In each size, four parts sit at the base power, at 1 and 5 percent, and two at the upgraded power. Our extract also holds commercial and anti-sulfuration high-power 47 ohm parts, which carry no AEC-Q200 tag in Walsin’s export. We have not seen Walsin’s 47 ohm automotive high-power ladder laid out by size and power anywhere else.

Which Walsin parts cross a 47 ohm, 1 W AEC-Q200 balancing brief?

Five match. For 47 ohm, 1 percent, tagged AEC-Q200 and rated 1 W or more, WF20P47R0FTLJ (2010, 1 W), WF20A47R0FTLJ (2010, 1.5 W), WF25P47R0FTLJ and MF25P47R0FTL (2512, 2 W) and WF25A47R0FZLJ (2512, 3 W) fit; the 1206 part and the untagged 2512 parts miss.

Brief: 47 Ω, ±1%, ≥ 1 W, AEC-Q200 Walsin part Size, power Match / mismatch Your incumbent
Smallest fit WF20P47R0FTLJ 2010, 1 W Match
More power in 2010 WF20A47R0FTLJ 2010, 1.5 W Match
2512 fit WF25P47R0FTLJ 2512, 2 W Match
2512, second series MF25P47R0FTL 2512, 2 W Match
Most power WF25A47R0FZLJ 2512, 3 W Match
Smaller case WF12P47R0FTLJ 1206, 1/2 W Mismatch in power
Commercial WF25P47R0FTL 2512, 2 W Mismatch: no AEC-Q200 tag
Anti-sulfuration SF25P47R0FTP 2512, 2 W Mismatch: no AEC-Q200 tag; ≤ ±200 ppm/°C

All of the AEC-Q200 matches list 100 ppm/°C or better at 1 percent. Leave the last column for your current part, and note that WF25P47R0FTL and WF25P47R0FTLJ differ only by the trailing J: in this family that letter marks Walsin’s automotive grade, so read the last character before you approve a cross.

How much margin does a balancing resistor need at 4.2 V?

More than the room-temperature rating suggests. About 0.38 W at 4.2 V and 47 ohm uses 75 percent of a 1/2 W 1206 at 25 °C, while a 1 W 2010 runs at about 38 percent and a 2 W 2512 at under 20 percent, before any derating for a warm pack.

Thick film chip resistors derate above a knee temperature given in the datasheet, and a BMS board inside a pack can sit well above room temperature at the end of a charge. Several balancing resistors switched on together also heat each other. That is why many designs either split the load across two parts or step up to 2010 or 2512. For bench and fixture work, WR12X470 JTL (47 ohm, 1206, 1/4 W) and WR25X330 JTL (33 ohm, 2512, 1 W) are on our shelf in Hong Kong (snapshot 9 Nov 2026); both are general purpose parts from Walsin’s ASC_WR.pdf family, not AEC-Q200, so not for vehicle packs. The automotive parts are to order: request a quote and we source them through our authorised Walsin channel. The chip resistor range page lists every series.

How Venatech helps: what can we supply to a Karawang battery pack team?

Crosses for the whole BMS board, in one pass. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, including all 14,954 Walsin automotive high-power resistors.

Paste your balancing, sense and divider resistor lines into the cross-reference tool, upload the BOM at /bom/, or see the dated ready stock list. We serve Indonesia from Hong Kong in small lots, which suits samples and pre-series builds, and we quote fast. We confirm availability, date code and lead time on each quote and promise none in advance; qualification stays with your engineers, and import questions with your compliance team. Our posts on the AEC-Q200 qualification report to ask for and what resistor TCR actually buys you cover the paperwork and the drift.

The short version

  • CATL and IBC’s Karawang cell plant began operating in July 2026 with 6.9 GWh, rising to at least 15 GWh (Indonesian Mining Association, 15 September 2026).
  • Walsin lists 14,954 automotive high-power chip resistors tagged AEC-Q200; 36 of them are 47 ohm.
  • For 47 ohm, 1 percent and 1 W or more, five parts in 2010 and 2512 match.
  • At 4.2 V a 47 ohm balancing resistor dissipates about 0.38 W; size for the warm pack, not the bench.

Send us the balancing resistors from your BMS and we will return the Walsin crosses with every difference stated. How hot does your balancing bank run at the end of a full charge?

Related reading

Last reviewed: 17 November 2026.

Sources

Fetched 17 November 2026.

  • Indonesian Mining Association, Pabrik baterai EV terbesar ke-2 RI sudah beroperasi Juli 2026, 15 September 2026: https://ima-api.org/pabrik-baterai-ev-terbesar-ke-2-ri-sudah-beroperasi-juli-2026/
  • Investortrust, Indonesia charges its EV ambitions as giant CATL-IBC battery plant begins trial runs in West Java, reporting officials’ confirmation of 21 August 2026: https://investortrust.id/market/113741/indonesia-charges-its-ev-ambitions-as-giant-catl-ibc-battery-plant-begins-trial-runs-in-west-java
  • Venatech chip resistor upload files Venatech_ChipR_Upload_01.xlsx to _79.xlsx and Walsin’s ASC_WFxxP_J_AUTO.pdf, ASC_WFxxA_J_AUTO.pdf, ASC_MFxxP_AUTO.pdf, ASC_SFxxP_TP.pdf and ASC_WR.pdf datasheets as linked in the export, re-measured 17 November 2026; Venatech ready stock snapshot dated 9 November 2026.

Frequently asked questions

How many AEC-Q200 47 ohm high-power resistors does Walsin make?

36 in our count of 17 November 2026, six in each of 0603, 0805, 1206, 1210, 2010 and 2512, from 1/8 W to 3 W.

Which Walsin part is a 47 ohm, 1 W automotive balancing resistor?

WF20P47R0FTLJ in 2010 at 1 W, or WF25P47R0FTLJ and MF25P47R0FTL in 2512 at 2 W, all 1 percent. Confirm derating against both datasheets.

What value should a cell balancing resistor be?

Set it from cell capacity, the balancing time you want and the BMS switch rating; a few tens to a few hundreds of ohms is common. At 4.2 V, 47 ohm bleeds about 89 mA.

Does a balancing resistor need AEC-Q200?

In vehicle packs, carmakers usually require it for passives. Walsin’s export tags its automotive high-power series AEC-Q200; ask for the qualification report for the part you approve.

Does Venatech stock balancing resistors for Indonesia?

We hold stock in Hong Kong. Two general purpose 1206 and 2512 lines are on our shelf in Hong Kong (snapshot 9 Nov 2026) for bench use; the AEC-Q200 parts are quoted through our authorised Walsin channel.

Can Venatech supply battery pack makers in Karawang, Indonesia?

Yes. Venatech is the authorised Walsin distributor in Hong Kong and quotes small lots to Indonesia. Use the cross-reference tool or upload a BOM; confirm import rules with your compliance team.


Share This, Choose Your Platform!