NEWS

Shunt Resistor for E-Bike Electronics in Germany: 1.3 Million E-Bikes Built in 2025 and 131 Walsin 2 W 2512 Metal Shunts Cross Stackpole CSNL2512

A shunt resistor is how an e-bike battery pack and motor controller know their current. For Germany, which built about 1.3 million e-bikes in 2025, Walsin lists 131 metal shunts at 2 W in 2512 from 1 to 10 milliohm, the same window as Stackpole CSNL2512. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for hardware engineers and buyers at German makers of e-bike drive units, battery management systems, motor controllers and chargers. Walsin Technology (Walsin) is the line we are authorised for; Stackpole Electronics (SEI) is a line we supply, so a CSNL2512 or CSRN2512 already on your parts list can be quoted as it is or crossed to Walsin. We measured every Walsin figure below on 17 November 2026 in our Walsin exports Metal_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx and Thick_Film_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx, counting distinct part numbers, and checked our ready stock snapshot dated 9 November 2026. Stackpole figures come only from Stackpole’s resistors-for-medical-applications release of 2 May 2019 on seielect.com, fetched on 17 November 2026; the CSNL datasheet on seielect.com did not load for us that day, so confirm each Stackpole figure against it.

How many e-bikes did Germany build and sell in 2025?

About 1.3 million built and about 2.0 million sold. The German bicycle industry association ZIV reported at its market press conference on 11 March 2026 that e-bike production in Germany fell 3 percent to 1.3 million units in 2025, while e-bike sales of about 2.0 million took 52.7 percent of the market.

Bike Europe’s June 2026 edition, drawing on the same ZIV figures, put German e-bike production at 1,285,000 units and bicycle production up 3 percent at 658,000. ZIV also reported e-bike sales down 4.8 percent on the year. Those are ZIV’s figures, not ours. A market that holds at around two million e-bikes a year, with more than a million built at home, keeps a steady demand for battery packs, drive units and controllers, and each one senses current at least twice: in the battery management system and in the motor controller.

Where does a shunt resistor sit in an e-bike battery and motor controller?

In the pack’s discharge path and the inverter’s low side. The battery management system reads a low-ohm shunt in the pack’s negative path for state of charge and overcurrent cut-off; the motor controller reads one or more shunts in the inverter legs or DC link for torque control and short-circuit trips.

The current window is modest compared with a car but the board space is tight. By the square-root-of-power-over-resistance rule, a 2 W shunt carries about 44.7 A at 1 milliohm, 25.8 A at 3 milliohm, 20.0 A at 5 milliohm and 14.1 A at 10 milliohm. A 36 V or 48 V pedelec pack typically runs well inside that, with peaks on hill starts. Stackpole’s release of 2 May 2019 makes the same point for mobility products: it names CSNL2512, a metal element shunt, for higher current or surge needs in wheelchairs and scooters, against CSRN2512, a thick film part, for lighter duty. Our low-ohm current sense: thick film versus metal note explains the difference.

How many Walsin 2 W 2512 metal shunts run from 1 to 10 milliohm?

  1. We filtered Walsin’s metal current sense rows to 2512 and 2 W between 1 and 10 milliohm and counted 131 distinct part numbers at all 10 whole-milliohm values; 70 are 1 percent, 60 are 5 percent and 1 is 0.5 percent.
Walsin family in the export Parts, 2 W 2512, 1 to 10 milliohm TCR classes (export) Example
Metal plate power, general 60 50, 70 and 75 ppm WW25RR001FTL, WW25KR005FTL
Metal plate power, automotive 40 70 and 100 ppm WW25RR005FTLJ
Metal plate, automotive 20 50 and 70 ppm WW25NR005FTLJ
Metal foil power sensing 11 50 and 100 ppm WW25DR005FTL

By TCR, 35 of the 131 parts are 50 ppm, 66 are 70 ppm, 20 are 75 ppm and 10 are 100 ppm, and 60 carry the automotive series tag. We have not seen this 2 W cell counted by family elsewhere. Our export has no current column, so the amps in this post come from the power-and-resistance rule; confirm them in Walsin’s datasheet.

Which Walsin parts cross a Stackpole CSNL2512 or CSRN2512 shunt?

On size, power and value across the whole 1 to 10 milliohm window. Stackpole’s release of 2 May 2019 describes CSNL2512 as a 2 W, 2512 metal element shunt from 1 to 10 milliohm and CSRN2512 as a 2 W, 2512 thick film current sense part over the same range.

Your brief (CSNL2512 or CSRN2512 style) Walsin part Walsin size, power, TCR (export) Match / mismatch Your incumbent
1 milliohm, 2 W, metal WW25RR001FTL 2512, 2 W, 1 percent, 75 ppm Match on size, value, power; TCR: compare to your datasheet
3 milliohm, 2 W, metal, low drift WW25NR003FTL 2512, 2 W, 1 percent, 50 ppm Match on size, value, power and a 50 ppm class
5 milliohm, 2 W, metal WW25KR005FTL 2512, 2 W, 1 percent, 70 ppm Match on size, value, power
10 milliohm, 2 W, metal WW25NR010FTL 2512, 2 W, 1 percent, 50 ppm Match on size, value, power
10 milliohm, 2 W, thick film (CSRN2512 style) WW25WR010FTL JH 2512, 2 W, 1 percent, 1,000 ppm Match on size, value, power; mismatch on TCR against any metal part

The thick film row shows why the metal choice matters: at 10 milliohm Walsin’s thick film 2512 part lists 1,000 ppm, while the metal parts sit at 50 to 75 ppm. Walsin’s export writes that thick film part number with a space before the JH tail, as shown.

What should a German e-bike electronics team check before switching shunts?

TCR across a cold start and a hot climb, then the pulse rating. Check TCR from a winter start to a hot hill climb, the pulse rating for short-circuit trips, and pad geometry; 70 ppm over an 80 degree span is a 0.56 percent shift in reading, which a fuel gauge will notice.

State-of-charge estimation integrates current over hours, so a small gain error grows into a range error; 50 ppm parts such as WW25NR003FTL are worth the look in the battery management system. In the motor controller, the short-circuit pulse matters more than drift: ask for the pulse and overload curves. Keep Kelvin routing on any new footprint. E-bike packs and chargers carry their own safety approvals; we give no certification or compliance advice, so confirm with your compliance team. Our battery storage shunt resistor note for Germany looks at higher-current packs, and current sense resistor TCR covers drift.

How Venatech helps

Cross the pack and controller boards in one paste. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating size, value, tolerance, TCR and power as match or mismatch.

Paste your shunt lines into the cross-reference tool, or upload the parts list at BOM upload. On our shelf in Hong Kong (snapshot 9 Nov 2026) are three Walsin 0805 thick film current sense lines, WW08WR270FTL, WW08WR390FTL and WW08WR470FTL, at 0.27, 0.39 and 0.47 ohm, 1 percent, 1/4 W, suited to charger and auxiliary rail sensing; see ready stock. The 2 W metal shunts are not on it, so request a quote and we source them through our authorised Walsin channel. Stackpole CSNL2512 and CSRN2512 lines can be quoted too; Stackpole is a line we supply, and Walsin is the line we are authorised for. We serve German buyers from Hong Kong in small lots and confirm availability, date code and lead time on each quote, with no price, lead-time or stock guarantee. The chip resistor range lists every Walsin family.

The short version

  • ZIV reported on 11 March 2026 that Germany built about 1.3 million e-bikes in 2025 and sold about 2.0 million.
  • Walsin lists 131 metal shunts at 2 W in 2512 from 1 to 10 milliohm; 35 are 50 ppm and 60 are automotive.
  • Stackpole CSNL2512 has Walsin matches on size, power and value across the whole window.
  • Check TCR, pulse rating and pad layout before you switch; thick film at 10 milliohm drifts far more.

Send us the shunt lines from your pack or controller, and we will return the Walsin crosses with every difference stated. What peak current does your controller see on a steep start?

Related reading

Last reviewed: 17 November 2026.

Sources

Fetched 17 November 2026.

  • ZIV, “Marktdaten Fahrradwirtschaft 2025”, press conference of 11 March 2026: https://www.ziv-zweirad.de/wp-content/uploads/2026/03/Marktdaten-Fahrradwirtschaft-2025.pdf
  • Bike Europe, “E-bike sales help stabilise German market”, June 2026 edition: https://onlinemagazine.bike-eu.com/en/edition-june-2026/e-bike-sales-help-stabilise-german-market
  • Stackpole Electronics release on resistors for medical applications, 2 May 2019: https://seielect.com/news/20190502_Resistors_for_Medical_Applications.pdf
  • Venatech Walsin current sense exports (Metal_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx, Thick_Film_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx) and ready stock snapshot dated 9 November 2026, re-measured 17 November 2026.

Frequently asked questions

What shunt resistor suits an e-bike battery management system in Germany?

Usually a 1 to 10 milliohm metal shunt in 2512 at 2 W. By the power rule it carries about 44.7 A at 1 milliohm and 20.0 A at 5 milliohm; choose the value for your peak discharge current and amplifier range, and confirm in the datasheet.

How many Walsin 2 W 2512 metal shunts are there from 1 to 10 milliohm?

131 distinct part numbers in our export, at all 10 whole-milliohm values: 70 at 1 percent, 60 at 5 percent and 1 at 0.5 percent, with 35 at 50 ppm.

Which Walsin part crosses a Stackpole CSNL2512 at 5 milliohm?

WW25KR005FTL, a 2512, 5 milliohm, 1 percent, 2 W metal plate part at 70 ppm in our export, or WW25NR005FTLJ for an automotive-series part at 50 ppm. Compare TCR and pad layout before you approve it.

Is a thick film shunt good enough for an e-bike controller?

For light duty and wide tolerance, sometimes; for state of charge, rarely. At 10 milliohm Walsin’s thick film 2512 part lists 1,000 ppm, against 50 to 75 ppm for the metal parts.

Do you hold shunt resistors on the shelf in Hong Kong for German orders?

Three Walsin 0805 thick film current sense lines are on our shelf in Hong Kong (snapshot 9 Nov 2026), at 0.27, 0.39 and 0.47 ohm. The 2 W metal shunts are not; request a quote and we source them through our authorised Walsin channel.

Is Venatech authorised for Stackpole?

No. Venatech is the authorised Walsin distributor in Hong Kong; Stackpole is a line we supply, and we quote Stackpole CSNL2512 and CSRN2512 lines alongside the Walsin cross.


Share This, Choose Your Platform!