NEWS

Thick Film Current Sense Resistor for Telecom Radios in Finland: Oulu’s 5G Campus and 758 Walsin 100 ppm Parts Cross Stackpole CSR

A thick film current sense resistor is the low-cost way to watch supply and amplifier current on a radio board. For telecom makers in Finland, Walsin lists 758 thick film current sense parts at 1 percent and 100 ppm from 0603 to 2512, across the Stackpole CSR range. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for hardware engineers and buyers at Finnish makers and contract manufacturers of 5G radio units, baseband boards, small cells and telecom power supplies. Walsin Technology (Walsin) is the line we are authorised for; Stackpole Electronics (SEI) is a line we supply, so a CSR already on your parts list can be quoted as it is or crossed to Walsin. We counted the Walsin figures below on 17 November 2026 in our Walsin export Thick_Film_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx, and checked our ready stock snapshot as at 9 November 2026. Stackpole figures come only from Stackpole’s current sensing product page on seielect.com, fetched the same day; the CSR datasheet did not load for us, so confirm each Stackpole figure against it.

What is Nokia building in Oulu?

A campus of about 55,000 square metres for radio R&D and manufacturing. Nokia said on 5 September 2025 that its new Oulu campus covers about 55,000 square metres of manufacturing, R&D and office space for around 3,000 people, and that its Oulu Factory handles new production introduction for Nokia’s 5G radio and baseband products.

Nokia calls Oulu its “Home of Radio” and named its Osprey and Habrok massive MIMO radios as examples of the work done there. Those are Nokia’s statements, not ours. New production introduction is where a bill of materials gets frozen, and where a second source for each passive is easiest to add. A radio unit has many transmit chains, each with a power amplifier whose drain current the controller watches, and each of those readings usually starts at a low-ohm chip resistor.

Where does a thick film current sense resistor sit in a 5G radio?

On every rail where current matters but milliohm precision does not. A thick film current sense resistor sits in power amplifier drain and bias monitoring, on point-of-load converter rails, in PoE and fan supplies, and in fault-detection paths, typically between 0.03 and 1 ohm.

Thick film suits these jobs because the currents are moderate and the readings are for protection and trending, not metering. Value and size come from the arithmetic: a 0.1 ohm resistor at 1.5 A drops 150 mV and dissipates 0.225 W. That is too much for a 1/8 W 0603 and tight for a 1/4 W 0805; a 1/3 W 1206 runs it at about two thirds of rating. Below about 20 milliohm, or where TCR must be tight, metal plate or metal foil takes over. Our low-ohm current sense: thick film vs metal note sets out where the line falls.

How many Walsin thick film current sense parts hold 100 ppm?

758 at 1 percent. Of 10,428 distinct Walsin thick film low-ohm current sense parts in our export, 1,501 carry a TCR of 100 ppm or better, and 758 of those are at 1 percent, from 0.033 to 0.91 ohm in six sizes from 0603 to 2512.

Walsin thick film current sense, 1 percent and 100 ppm Distinct parts
0603 50
0805 136
1206 152
1210 132
2010 132
2512 156
Total 758

Stackpole’s current sensing page, fetched 17 November 2026, describes CSR as a thick film current sensing chip resistor from 0201 to 1225, with narrow terminations in 2010 and 2512, at 1, 2 or 5 percent, from 0.003 to 7.5 ohm, at 100 ppm. Walsin’s 100 ppm thick film window sits inside the CSR’s sizes and middle values; we have not seen it counted elsewhere.

Which Walsin parts cross a Stackpole CSR?

The 0603 to 2512 middle of the range, at 100 ppm. For a CSR-style brief from about 0.03 to 0.91 ohm in 0603 to 2512, Walsin has a 1 percent, 100 ppm thick film part at the same size and value; at the very low and very small ends, the cross moves to another Walsin family or stays with the CSR.

Your brief (CSR style) Walsin part Walsin size, power, tolerance, TCR (export) Match / mismatch Your incumbent
0.1 ohm, 0603, 1 percent WW06WR100FTLJ 0603, 1/8 W, 1 percent, 100 ppm Match on size, value, tolerance, TCR
0.47 ohm, 0805, 1 percent WW08WR470FTL 0805, 1/4 W, 1 percent, 100 ppm Match; on our shelf in Hong Kong
0.22 ohm, 1206, 1 percent WW12WR220FTL 1206, 1/3 W, 1 percent, 100 ppm Match on size, value, tolerance, TCR
0.05 ohm, 1210, 1 percent WW10WR050FTL 1210, 2/3 W, 1 percent, 100 ppm Match on size, value, tolerance, TCR
0.01 ohm, 2512, 100 ppm WW25DR010FTL (metal foil) 2512, 2 W, 1 percent, 50 ppm Match on size, value; different technology, tighter TCR
0.05 ohm, 0201 WW02CR050JAL 0201, 1/10 W, 5 percent, 0 to 350 ppm Mismatch on tolerance and TCR; keep the CSR, which we can quote

What should a Finnish radio designer check before switching?

Power at the real current, then pads. Check that I squared R stays near half the rated power at the worst-case amplifier current, confirm the TCR keeps your fault threshold inside budget over the radio’s temperature range, then compare land patterns, especially for 2010 and 2512 narrow-termination CSR parts.

A 100 ppm part that rises 50 degrees shifts about 0.5 percent, which is fine for a protection threshold. Outdoor radios also see wide ambient swings, so take the worst-case enclosure temperature, not the lab bench. Requalification of a frozen design follows your own process and your operator customer’s; we give no compliance advice, so confirm with your compliance team. Our passives for a telecom base station front end note covers the rest of the radio board.

How Venatech helps

Cross the radio board in one paste. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating size, value, tolerance, TCR and power as match or mismatch.

Paste your sense resistor lines into the cross-reference tool, or upload the parts list at BOM upload. On our shelf in Hong Kong (snapshot 9 Nov 2026) are three of the 758 parts above, WW08WR270FTL, WW08WR390FTL and WW08WR470FTL, 0805 at 0.27, 0.39 and 0.47 ohm, 1 percent, 100 ppm, 1/4 W; see ready stock. For the rest, request a quote and we source them through our authorised Walsin channel. Stackpole CSR lines can be quoted too; Stackpole is a line we supply, and Walsin is the line we are authorised for. We serve Finnish buyers from Hong Kong in small lots and confirm availability, date code and lead time on each quote, with no price, lead-time or stock guarantee. The chip resistor range lists every Walsin family.

The short version

  • Nokia’s Oulu campus covers about 55,000 square metres and handles new production introduction for its 5G radio and baseband products, per Nokia on 5 September 2025.
  • Walsin lists 758 thick film current sense parts at 1 percent and 100 ppm from 0603 to 2512, from 0.033 to 0.91 ohm.
  • A Stackpole CSR brief in that window has a Walsin part at the same size and value; at 10 milliohm, cross to Walsin metal foil.
  • Three of the 758 are on our shelf in Hong Kong (snapshot 9 Nov 2026).

Send us the sense resistor lines from your radio or power board, and we will return the Walsin crosses with every difference stated. What is the highest continuous current your amplifier monitor sees?

Related reading

Last reviewed: 17 November 2026.

Sources

Fetched 17 November 2026.

  • Nokia, “Nokia opens new state-of-the-art R&D and manufacturing campus to deliver next-generation networks built for AI”, 5 September 2025: https://www.nokia.com/newsroom/nokia-opens-new-state-of-the-art-rd-and-manufacturing-campus-to-deliver-next-generation-networks-built-for-ai/
  • Stackpole Electronics current sensing product page: https://seielect.com/products/ProductSearch.asp?keyWord=current+sensing
  • Venatech Walsin export (Thick_Film_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx, with Metal_Low_Ohm_Current_Sense_Chip_Resistor__1of1.xlsx for the metal foil line) and ready stock snapshot dated 9 November 2026, re-measured 17 November 2026.

Frequently asked questions

What is a thick film current sense resistor used for in Finnish telecom radios?

It monitors power amplifier drain and bias current, point-of-load rails, PoE and fan supplies on radio and baseband boards, usually at values between 0.03 and 1 ohm where the reading is for protection rather than metering.

How many Walsin thick film current sense parts are at 1 percent and 100 ppm?

758 in our export, from 0.033 to 0.91 ohm in 0603, 0805, 1206, 1210, 2010 and 2512. They are part of 10,428 distinct Walsin thick film low-ohm current sense parts.

Which Walsin part crosses a Stackpole CSR at 0.47 ohm in 0805?

WW08WR470FTL, an 0805, 0.47 ohm, 1 percent, 100 ppm, 1/4 W part, which is on our shelf in Hong Kong (snapshot 9 Nov 2026). Compare the pad layout on both datasheets before you approve it.

What about a 10 milliohm CSR in 2512?

At 10 milliohm the Walsin thick film parts in our export carry a much wider TCR, so we cross to the metal foil part WW25DR010FTL, 2512, 1 percent, 50 ppm, 2 W. Check its footprint against yours.

Do you hold thick film current sense resistors in stock in Hong Kong?

Yes, three lines in the snapshot of 9 Nov 2026: WW08WR270FTL, WW08WR390FTL and WW08WR470FTL. For other values, request a quote and we source them through our authorised Walsin channel.

Is Venatech authorised for Stackpole?

No. Venatech is the authorised Walsin distributor in Hong Kong; Stackpole is a line we supply, and we quote Stackpole CSR lines alongside the Walsin cross.


Share This, Choose Your Platform!