An AEC-Q200 MLCC is a ceramic capacitor qualified to the automotive passive-component stress tests, and 100 nF in 0402 is its commonest value on vehicle boards. Walsin lists 13 AEC-Q200 MLCC at 0402 and 100 nF, rated 10 V to 50 V, in its MT and ST series. Venatech is the authorised Walsin distributor in Hong Kong.
Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for automotive electronics engineers and buyers in Kenitra, its Atlantic Free Zone and across Morocco, at harness, connector, ECU and EMS suppliers. Walsin Technology (Walsin) is the line we are authorised for. We parsed our MLCC upload files, Venatech_MLCC_Upload_01.xlsx to Venatech_MLCC_Upload_08.xlsx, on 16 November 2026 and counted distinct part numbers at 0402 and 100 nF by series. We kept the series Walsin names as qualified to AEC-Q200 apart from those it names as automotive without the certification. Every part number below is real.
What is Leoni building in Kenitra’s Atlantic Free Zone?
Its first cable plant in Africa, making automotive and in-vehicle data cables. Médias24 reported on 23 June 2026 that Leoni Cable Solutions laid the foundation stone for a 630 million dirham (60 million euro) factory in Kenitra’s Atlantic Free Zone, making single-core and multi-core automotive cables and data-transmission cables for vehicles.
The report describes a 48,000 square metre site with 18,000 square metres of industrial and office space and a 9,000 square metre reserve for expansion, and a training programme run by teams from the group’s sites in Turkey and Germany. Those are the publication’s figures, not ours. Cable is not a board, but it is the start of a chain: data cables end at connectors and ECUs, and Kenitra’s automotive cluster of harness, module and electronics suppliers builds and tests the boards those cables plug into.
Why does a Kenitra wiring or ECU supplier need an AEC-Q200 MLCC at 100 nF?
Because 100 nF is the default decoupling and coupling value on vehicle boards, and carmakers usually require AEC-Q200 for passives. AEC-Q200 sets the stress tests, temperature cycling, humidity, board flex and more, that a passive must pass for automotive use, and a 100 nF 0402 MLCC sits beside almost every IC, transceiver and connector on an ECU.
On in-vehicle data links, AC-coupling capacitors in series with each line block DC between the two ends, and 100 nF is a common choice there too; check the value your PHY or SerDes vendor specifies. Beyond that, the same part decouples microcontroller pins, sensor supplies and connector-side filters. Using one qualified part number across those positions keeps the approved vendor list short. Our posts on what AEC-Q200 actually certifies and AEC-Q200 compliant is not certified explain what to ask for.
How many AEC-Q200 MLCC at 0402 and 100 nF does Walsin list?
- We counted 51 Walsin MLCC at 0402 and 100 nF: 13 are AEC-Q200, 12 in the MT series and one in the ST soft termination series; the rest are 25 general purpose, 7 MG automotive parts without AEC-Q200 certification and 6 SH soft termination parts.
| MT and ST at 0402, 100 nF, X7R | 5 percent | 10 percent | 20 percent |
|---|---|---|---|
| 10 V | MT15B104J100 |
MT15B104K100 |
MT15B104M100 |
| 16 V | MT15B104J160 |
MT15B104K160, ST15B104K160 |
MT15B104M160 |
| 25 V | MT15B104J250 |
MT15B104K250 |
MT15B104M250 |
| 50 V | MT15B104J500 |
MT15B104K500 |
MT15B104M500 |
All 13 are X7R. Across every size, our extract holds 2,283 AEC-Q200 MLCC, 2,167 in MT and 116 in ST, and 486 of them are 0402: 279 C0G, 204 X7R and 3 X8G. We have not seen the 0402, 100 nF slice split by qualification counted anywhere else.
Which Walsin parts cross a 100 nF, 50 V, 0402 X7R AEC-Q200 brief?
Two match, and five more miss on one field each. At 100 nF, 50 V, X7R and AEC-Q200 in 0402, MT15B104K500 matches at 10 percent and MT15B104J500 at 5 percent; parts at 25 V or 16 V, at 20 percent, or without AEC-Q200 certification miss the brief.
| Brief: 100 nF, 50 V, X7R, 0402, AEC-Q200, 10% | Walsin part | Series | Match / mismatch | Your incumbent |
|---|---|---|---|---|
| Direct fit | MT15B104K500 |
MT | Match | |
| Tighter tolerance | MT15B104J500 |
MT | Match, 5 percent | |
| Looser tolerance | MT15B104M500 |
MT | Mismatch in tolerance (20 percent) | |
| Lower voltage | MT15B104K250 |
MT | Mismatch in voltage (25 V) | |
| Soft termination | ST15B104K160 |
ST | Mismatch in voltage (16 V); thickness 0.50 ±0.20 mm | |
| Automotive, not certified | MG15B104K250 |
MG | Mismatch: no AEC-Q200 certification | |
| General purpose | 0402B104K500 |
General Purpose | Mismatch: no AEC-Q200 |
Leave the last column for your current part. Check the thickness tolerance as well as the value: the MT parts list 0.50 ±0.05 mm, while ST15B104K160 lists 0.50 ±0.20 mm, which can matter under a shield can or a tight stencil. Our guide on how to cross-reference an MLCC sets out the order of checks.
What separates Walsin MT, ST and MG parts at the same value?
The qualification and the termination. MT is Walsin’s automotive series qualified to AEC-Q200, ST adds soft termination to an AEC-Q200 part, and MG is an automotive-grade series that Walsin’s own export labels as without AEC-Q200 certification, so only MT and ST meet an AEC-Q200 requirement.
MG parts can still suit industrial or non-safety boards where AEC-Q200 is not required. Our comparison of AEC-Q200 MLCC: MT versus MG series goes further, and the MLCC range page lists every series. For bench builds and test fixtures, six general purpose 0402 100 nF lines, including 0402B104K500 and 0402B104K160, are on our shelf in Hong Kong (snapshot 9 Nov 2026); they are not AEC-Q200 and are not for vehicle production. The MT and ST parts are to order: request a quote and we source them through our authorised Walsin channel.
How Venatech helps: what can we supply to a Kenitra automotive team?
A cross for every capacitor and resistor on the BOM, in one pass. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, including all 2,283 AEC-Q200 MLCC in Walsin’s MT and ST series.
Paste your 0402 lines into the cross-reference tool, upload the BOM at /bom/, or see the dated ready stock list. We serve Morocco from Hong Kong in small lots, which suits samples and pre-series builds, and we quote fast. We confirm availability, date code and lead time on each quote and promise none in advance; PPAP and qualification stay with you, and import questions with your compliance team.
The short version
- Leoni Cable Solutions began a 630 million dirham automotive and data-cable plant in Kenitra’s Atlantic Free Zone (Médias24, 23 June 2026).
- Walsin lists 51 MLCC at 0402 and 100 nF; 13 are AEC-Q200, 12 in MT and one in ST.
- For 100 nF, 50 V, 0402 X7R AEC-Q200, MT15B104K500 and MT15B104J500 match.
- Walsin’s MG series is automotive grade but labelled without AEC-Q200 certification.
Send us the 0402 capacitors from your ECU or connector board and we will return the AEC-Q200 Walsin crosses with every difference stated. Which voltage rating does your coupling position call for?
Related reading
- What AEC-Q200 actually certifies
- AEC-Q200 MLCC: MT versus MG series
- AEC-Q200 qualification paperwork
- Cross-reference tool, BOM upload and ready stock snapshot
Last reviewed: 16 November 2026.
Sources
Fetched 16 November 2026.
- Médias24, Leoni Cable Solutions launches its first African factory in Kenitra, 23 June 2026: https://medias24.com/2026/06/23/automobile-for-630-million-dirhams-leoni-cable-solutions-launches-its-first-african-factory-in-kenitra-1708485/
- Venatech MLCC upload files Venatech_MLCC_Upload_01.xlsx to _08.xlsx and Walsin’s WTC_MLCC_Automotive_MT.pdf and WTC_MLCC_MG_Series_Cap.pdf datasheets as linked in the export, re-measured 16 November 2026; Venatech ready stock snapshot dated 9 November 2026.
Frequently asked questions
How many AEC-Q200 MLCC does Walsin make at 0402 and 100 nF?
13 in our count of 16 November 2026: 12 in the MT series at 10, 16, 25 and 50 V in 5, 10 and 20 percent, and ST15B104K160 in the soft termination ST series. All are X7R.
Which Walsin part is a 100 nF, 50 V, 0402 AEC-Q200 capacitor?
MT15B104K500 at 10 percent, or MT15B104J500 at 5 percent. Confirm thickness, footprint and DC bias against both datasheets.
Is Walsin’s MG series AEC-Q200?
No. Walsin’s export labels the MG series as automotive caps without AEC-Q200 certification. For an AEC-Q200 requirement, use the MT or ST series.
What value is an automotive Ethernet AC coupling capacitor?
100 nF is a common choice, but take the value, voltage and tolerance from your PHY vendor’s guide. Walsin’s MT series covers 100 nF in 0402 from 10 V to 50 V.
Does Venatech stock AEC-Q200 MLCC for Morocco?
We hold stock in Hong Kong. The MT and ST 0402 100 nF parts are quoted through our authorised Walsin channel; six general purpose 0402 100 nF lines are on our shelf in Hong Kong (snapshot 9 Nov 2026) for bench use.
Can Venatech supply automotive suppliers in Kenitra, Morocco?
Yes. Venatech is the authorised Walsin distributor in Hong Kong and quotes small lots to Morocco. Use the cross-reference tool or upload a BOM; confirm import rules with your compliance team.