An anti-sulfur resistor keeps a marine control board in Norway reading true where engine-room and exhaust air carries sulfur. At 4.7 kilohm and 1 percent, Walsin lists 25 automotive anti-sulfur parts that match Stackpole RMCA standard power in all eight sizes from 0201 to 2512. Venatech is the authorised Walsin distributor in Hong Kong.
Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for hardware engineers and buyers at Norwegian makers of navigation, dynamic positioning, engine and propulsion control, sensor and vessel automation electronics. Walsin Technology (Walsin) is the line we are authorised for; Stackpole Electronics (SEI) is a line we supply, so an RMCA already on your parts list can be quoted as it stands or crossed to Walsin. We counted every Walsin figure below on 16 November 2026 in our Walsin chip resistor export, the Thick_Film_General_Purpose and Thick_Film_High_Power .xlsx files, and checked our ready stock snapshot dated 9 November 2026. Stackpole figures come only from the RMCA datasheet, SEI-RMCA.pdf on seielect.com, fetched the same day.
How busy is Norway’s maritime technology sector in 2026?
Busier than ever on its order book. Kongsberg Maritime reported on 30 October 2026 a record order backlog of 29,753 million Norwegian kroner at the end of the third quarter, with revenue of 6,639 million kroner, about 5 percent higher year on year, and order intake of 8,323 million kroner.
The same report said the company supplies systems to more than 30,000 vessels across merchant, offshore, fishing and naval segments, and that newbuild deliveries grew 16 percent in the quarter. Those are Kongsberg Maritime’s figures, not ours, and we make no claim about whose components it uses. For a Norwegian board designer the point is the environment: marine electronics run for decades in engine rooms, thruster rooms and exhaust-treatment spaces, which is where sulfur attacks ordinary chip resistors. Our note on surge and safety parts for Denmark wind and marine covers the protection side of the same boards.
Why does a marine board need an anti-sulfur resistor?
Because silver and sulfur do not mix. A standard thick film chip resistor has a silver inner termination; sulfur compounds in the air react with it to form silver sulfide, which grows until the resistance rises or the part goes open, often after years in service.
Engine and exhaust spaces, scrubber rooms and bilges, and rubber gaskets and sealants inside enclosures all release sulfur compounds. An anti-sulfur resistor protects or replaces that silver layer. Stackpole’s RMCA datasheet describes an inner termination engineered to deter sulfur contamination and lists a sulfur test referenced to ASTM B809, alongside AEC-Q200 qualification and a range of -55 to +155 degree C. Walsin names its own families “Anti-Sulfuration” and carries automotive versions in two series: General Purpose Anti-Sulfuration and High Grade Anti-Sulfuration. A 4.7 kilohm, 1 percent part is a common pull-up, divider and bias value on control and sensor boards, which makes it a useful test of coverage.
How many Walsin anti-sulfur parts answer a 4.7 kilohm, 1 percent brief?
36, 25 of them automotive. We filtered Walsin’s anti-sulfur chip resistor rows to 4.7 kilohm at 1 percent: 36 part numbers come back, 25 in the two automotive series across all eight sizes from 0201 to 2512, and 11 in the high-power anti-sulfuration series.
| Size | Walsin automotive anti-sulfur parts, 4.7 kilohm, 1 percent | Rated power (export) | Example | Match / mismatch with RMCA standard power |
|---|---|---|---|---|
| 0201 | 2 | 0.05 W | WR02X4701FALV |
Match, 0.05 W |
| 0402 | 4 | 0.0625 and 0.1 W | WR04X4701FTLV |
Match, 0.063 W |
| 0603 | 4 | 0.1 W | SR06X4701FTL |
Match, 0.1 W |
| 0805 | 4 | 0.125 and 0.25 W | WR08X4701FTLV |
Match, 0.125 W |
| 1206 | 4 | 0.25 W | SR12X4701FTL |
Match, 0.25 W |
| 1210 | 3 | 0.33 and 0.5 W | SR10X4701FTL |
Match, 0.5 W |
| 2010 | 2 | 0.75 W | SR20X4701FTL |
Match, 0.75 W |
| 2512 | 2 | 1 W | SR25X4701FTL |
Match, 1 W |
All 25 are 100 ppm, except the two 0201 parts at 200 ppm. Across all values, our export holds 23,530 automotive anti-sulfuration part numbers in those two series. We have not seen the 4.7 kilohm automotive anti-sulfur cell counted size by size anywhere else.
Which Walsin parts cross a Stackpole RMCA at 4.7 kilohm?
All eight standard sizes, and six of seven high-power ones. Stackpole rates RMCA standard parts from 0.05 W in 0201 to 1 W in 2512, and RMCA-HP from 0.1 W in 0402 to 2 W in 2512; Walsin anti-sulfur parts match every standard rating and every HP rating except 1210 at 0.66 W.
| Your RMCA brief, 4.7 kilohm, 1 percent | RMCA rating (Stackpole datasheet) | Walsin part | Walsin (export) | Match / mismatch | Your incumbent |
|---|---|---|---|---|---|
| 1206 standard | 0.25 W, 200 V | SR12X4701FTL |
automotive, 0.25 W, 100 ppm | Match on size, power, tolerance, grade | |
| 0402 HP | 0.1 W | SR04X4701FTL |
automotive, 0.1 W, 100 ppm | Match on size, power, tolerance, grade | |
| 0805 HP | 0.25 W | SR08X4701FTL |
automotive, 0.25 W, 100 ppm | Match on size, power, tolerance, grade | |
| 1206 HP | 0.5 W | WF12P4701FTLV |
high-power anti-sulfuration, 0.5 W | Match on power; mismatch on grade, no automotive tag | |
| 2010 HP | 1 W | WF20P4701FTLV |
high-power anti-sulfuration, 1 W | Match on power; mismatch on grade | |
| 2512 HP | 2 W | WF25P4701FTLV |
high-power anti-sulfuration, 2 W | Match on power; mismatch on grade | |
| 1210 HP | 0.66 W | SR10X4701FTL at 0.5 W |
automotive, 0.5 W | Mismatch on power: derate or move to 2010 |
What should a Norwegian marine electronics team check before swapping?
The sulfur test first. Compare the sulfur-test method, temperature, duration and allowed resistance change on both datasheets, then power at your hottest enclosure temperature, then the grade your documentation needs; a 4.7 kilohm pull-up at 5 V dissipates about 5 mW, so sulfur, not watts, usually decides.
Where a board shares parts with a vehicle or rail programme, the automotive Walsin series keep one part number across both. The automotive and AEC-Q200 claims are Walsin’s own; Venatech makes no qualification claim of its own, so request the qualification report for the exact part, as our note on Walsin automotive chip resistors and the AEC-Q200 split explains. Classification-society type approval for marine equipment follows its own rules; we give no certification or trade-compliance advice, so confirm with your compliance team.
How Venatech helps
Cross the whole board in one paste. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch at /cross-reference/ decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, with an anti-sulfur and automotive filter and every field shown as match or mismatch.
Paste your RMCA lines into the cross-reference tool, or upload a BOM. We checked our ready stock: the general-purpose 4.7 kilohm, 1 percent parts WR04X4701FTL, WR06X4701FTL and WR08X4701FTL are on our shelf in Hong Kong (snapshot 9 Nov 2026), for boards that do not need sulfur protection; the anti-sulfur crosses we source through our authorised Walsin channel on request. Stackpole RMCA lines are quoted too; Stackpole is a line we supply. We serve from Hong Kong in small lots, and we confirm availability, date code and lead time on each quote, with no price, lead-time or stock guarantee. The chip resistor range lists every Walsin family.
The short version
- Kongsberg Maritime reported a record order backlog of 29,753 million kroner on 30 October 2026.
- At 4.7 kilohm and 1 percent, Walsin lists 36 anti-sulfur parts, 25 automotive across all eight sizes.
- Walsin matches Stackpole RMCA standard power in all eight sizes and RMCA-HP in six of seven.
- Three general-purpose 4.7 kilohm parts are on our shelf in Hong Kong (snapshot 9 Nov 2026).
Send us the resistor lines from your engine, propulsion or navigation board, and we will return the anti-sulfur Walsin crosses with every difference stated. Which of your enclosures sits closest to the exhaust?
Related reading
- Surge and safety parts for Denmark wind and marine
- Anti-sulfuration resistors: SF thin film and SA arrays
- Chip resistor power rating by case size
- Cross-reference tool, BOM upload and ready stock snapshot
Last reviewed: 16 November 2026.
Sources
Fetched 16 November 2026.
- Kongsberg Maritime ASA, “Kongsberg Maritime Q3 2026: Record high order backlog and solid execution”, 30 October 2026: https://mfn.se/all/a/kongsberg-maritime/kongsberg-maritime-q3-2026-record-high-order-backlog-and-solid-execution
- Stackpole datasheet, RMCA Series automotive anti-sulfur thick film chip resistor: https://www.seielect.com/catalog/SEI-RMCA.pdf
- Venatech Walsin chip resistor export (Thick_Film_General_Purpose and Thick_Film_High_Power .xlsx files) and ready stock snapshot dated 9 November 2026, re-measured 16 November 2026.
Frequently asked questions
Why do Norwegian marine electronics need an anti-sulfur resistor?
Engine rooms, exhaust-treatment spaces, bilges and enclosure gaskets release sulfur compounds that attack the silver inner termination of a standard chip resistor, raising its resistance or opening it over years. An anti-sulfur resistor protects that termination.
How many Walsin anti-sulfur resistors are there at 4.7 kilohm, 1 percent?
36 in our export: 25 in the two automotive anti-sulfuration series across all eight sizes from 0201 to 2512, and 11 in the high-power anti-sulfuration series.
Which Walsin part crosses a Stackpole RMCA 1206 at 4.7 kilohm?
SR12X4701FTL, a 1206, 4.7 kilohm, 1 percent automotive anti-sulfuration part at 0.25 W and 100 ppm in our export. It matches RMCA 1206 standard on size, power, tolerance and grade.
Is there a Walsin cross for RMCA-HP in 1210?
Not at the same power: RMCA-HP 1210 is rated 0.66 W, and Walsin’s 1210 anti-sulfur parts at 4.7 kilohm reach 0.5 W. Derate, or move to a 2010 part such as WF20P4701FTLV at 1 W.
Do you hold anti-sulfur resistors on your shelf in Hong Kong?
Not at 4.7 kilohm on our snapshot dated 9 November 2026; three general-purpose 4.7 kilohm parts are on the shelf. Request a quote and we source the anti-sulfur parts through our authorised Walsin channel.
Is Venatech authorised for Stackpole?
No. Venatech is the authorised Walsin distributor in Hong Kong; Stackpole is a line we supply, and we quote Stackpole RMCA lines alongside the Walsin cross.