For a 0402 MLCC on a data centre board built in Brazil, Walsin Technology (Walsin) lists 3,979 part numbers in 0402 and 26 of them at exactly 1 µF, in X5R, X6S and X7R. Venatech, Walsin’s authorised distributor in Hong Kong, crosses each one against your incumbent and quotes it for Brazil.
Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for a hardware or purchasing engineer in Brazil whose boards go into data centre racks: servers, storage, switches and the power shelves that feed them. We parsed Walsin’s MLCC export 00_ALL_MLCC_parts_combined.xlsx (24,026 rows, 23,601 distinct part numbers) and our stock snapshot as at 9 November 2026. The news below was fetched on 17 November 2026, and every figure names its source and date.
What did the new US AI-chip rule say about data centres in Brazil?
It names Brazil as one of five higher-risk countries. O Povo reported on 16 November 2026 that the US Department of Commerce issued a rule requiring licences for exports, re-exports and transfers of advanced AI chips, and that it lists Brazil, with Singapore, Malaysia, Thailand and Indonesia, as having an above-normal risk of diversion.
The same report says the licence requirement applies to data centres supplying more than 12 million units of processing performance to companies in Macau or in Country Group D:5, and that US-based operators are exempt if they block access by restricted nations. It also quotes the Brazilian Data Center Association (ABDC) estimate that Brazil could attract up to 1 trillion reais of data centre investment, driven mainly by AI demand. Export-control questions belong with your compliance team; we give no legal or customs advice. What does not change is the passive bill of materials around every board, and that is where we can help.
Why does a data centre board in Brazil use so many 0402 MLCC?
Because decoupling dominates the parts count. On a typical server, storage or switch board, the 0402 MLCC is the workhorse decoupling and bypass part: it sits close to every power pin of the processor, memory, network controller and voltage regulator, and a single board can carry hundreds of them.
The 0402 case (1.0 x 0.5 mm) is small enough to place right under a BGA, yet large enough to hold 1 µF at the low voltages that core and I/O rails use. Many designs use 0402 for most of the bypass network and keep 0603 and 0805 for bulk storage near the regulator. Our note on why case size beats capacitance at the package explains the inductance side, and passives for AI server power stages covers the regulator end of the same board.
How many 0402 MLCC does Walsin list, and how many reach 1 µF?
3,979 in 0402, and 59 at 1 µF or more. We counted 3,979 distinct 0402 part numbers in Walsin’s MLCC export. Of those, 59 reach 1 µF or more, and 26 sit at exactly 1 µF: 13 in X5R, 10 in X6S and 3 in X7R.
| Walsin 0402 MLCC, measured 17 Nov 2026 | Part numbers |
|---|---|
| All 0402 part numbers | 3,979 |
| NP0 (C0G) | 2,996 |
| X7R | 784 |
| X5R | 153 |
| X6S | 32 |
| At 1 µF or more | 59 |
| At exactly 1 µF | 26 |
| 1 µF parts on our shelf in Hong Kong (snapshot 9 Nov 2026) | 5 |
The 26 parts at 1 µF come from three series: 23 in Walsin’s general-purpose range, 2 in the TT low-profile series at 0.30 mm thick, and 1 in the SH soft-termination series. Rated voltage runs from 6.3 V to 35 V. We have not seen the 1 µF 0402 range counted this way anywhere else. The full MLCC range lists every family.
Which Walsin parts cross a 1 µF, 10 V, 0402 brief?
Five clean matches, and four near misses worth knowing. We filtered the export to 1 µF in 0402 at 10 percent tolerance and checked each row against a typical bypass brief: 1 µF, 0402, 10 V or more, X5R or better, 10 percent. Five rows match; the rest miss on voltage, tolerance or height.
| Walsin part | Dielectric | Rated voltage | Tolerance | Thickness (mm) | Match / mismatch with a 1 µF, 10 V, 0402, 10% brief | Your incumbent |
|---|---|---|---|---|---|---|
0402X105K100 |
X5R | 10 V | 10% | 0.50 ±0.05 | Match, on our shelf in Hong Kong (snapshot 9 Nov 2026) | |
0402X105K160 |
X5R | 16 V | 10% | 0.50 ±0.05 | Match, more voltage headroom | |
0402X105K250 |
X5R | 25 V | 10% | 0.50 ±0.05 | Match, on our shelf in Hong Kong (snapshot 9 Nov 2026) | |
0402S105K100 |
X6S | 10 V | 10% | 0.50 ±0.05 | Match, rated to 105 °C | |
0402S105K250 |
X6S | 25 V | 10% | 0.50 ±0.20 | Match, but check the wider height tolerance | |
0402X105K6R3 |
X5R | 6.3 V | 10% | 0.50 ±0.05 | Mismatch: 6.3 V, below the brief; on our shelf | |
0402B105K6R3 |
X7R | 6.3 V | 10% | 0.50 ±0.05 | Mismatch: 6.3 V, though X7R; on our shelf | |
TT15X105K6R3 |
X5R | 6.3 V | 10% | 0.30 ±0.03 | Mismatch: 6.3 V; useful only where height is the constraint | |
0402X105M100 |
X5R | 10 V | 20% | 0.50 ±0.05 | Mismatch: 20% tolerance |
If your incumbent sits on a 0.9 V or 1.8 V rail, a 6.3 V part may be exactly what the original design used, so the mismatch is against our sample brief, not against your board. Confirm against both datasheets and qualify in your own circuit.
What should a Brazilian team check before it second-sources a 0402 MLCC?
Three things matter most: DC bias, temperature class and height. A 1 µF 0402 X5R part can lose a large share of its capacitance under DC bias, X5R stops at 85 °C while X6S runs to 105 °C, and thickness tolerance decides whether the part fits under a heatsink or inside a tight BGA field.
Start with DC bias. Class II capacitance falls as the applied voltage rises, and the effect is stronger in small cases, so a 10 V or 16 V rating on a 1.2 V rail is often chosen for the capacitance it keeps, not for the voltage. Our note on MLCC DC bias and voltage derating walks through the mechanism. Next, temperature: a part next to a hot processor or voltage regulator in a dense rack may sit well above room temperature, which is where X6S earns its place over X5R. Finally, height: the X6S 25 V parts carry a ±0.20 mm thickness tolerance in the export, against ±0.05 mm for most others.
Which 1 µF 0402 MLCC are on the Hong Kong shelf?
Five lines at 1 µF, and 162 0402 lines in all. Our stock snapshot as at 9 November 2026 holds 162 distinct Walsin 0402 MLCC part numbers, and 5 of the 26 at 1 µF: 0402X105K100, 0402X105K250, 0402X105K6R3, 0402B105K6R3 and 0402S105K6R3.
They are on our shelf in Hong Kong (snapshot 9 Nov 2026). Other values are to order: request a quote and we source them through our authorised Walsin channel. The ready-stock list is a dated snapshot, never live-synced, and we make no stock, price or lead-time promise; we confirm availability, date code and lead time on each quote.
How Venatech helps
How Venatech helps a data centre hardware team in Brazil is a 0402 MLCC cross with every difference shown. Venatech Limited, Walsin’s authorised distributor in Hong Kong, runs VenaMatch, which decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin; each cross states where the Walsin part differs from your original.
Paste your capacitor codes into the cross-reference tool, or upload the whole BOM and request a quote through the site. Check the ready-stock snapshot, dated 9 November 2026. We serve Brazilian teams from Hong Kong, in small lots with fast quotes. Walsin is the line we are authorised for; Stackpole and Viking are lines we supply. We give no export-control, customs or compliance advice; confirm that with your own team.
The short version
O Povo reported on 16 November 2026 that a new US Commerce rule on advanced AI chips names Brazil among five countries with above-normal diversion risk, while the ABDC sees up to 1 trillion reais of data centre investment ahead. Whatever happens to the chips, the boards around them need passives. Walsin lists 3,979 parts as 0402 MLCC, 26 of them at 1 µF, and five of those are on our Hong Kong shelf.
Send us your 0402 bypass lines and we will return Walsin crosses with every difference stated. Which of your rails is the one where DC bias bites hardest?
Related reading
- Decoupling at the package: why case size beats capacitance
- MLCC DC bias and voltage derating
- Passives for AI server power stages
- Cross-reference tool, BOM upload and ready-stock snapshot
Last reviewed: 17 November 2026
Sources
Fetched 17 November 2026.
- O Povo, report on the US Department of Commerce licence rule for advanced AI chips and data centres in Brazil, 16 November 2026: https://mais.opovo.com.br/jornal/economia/2026/11/16/data-centers-no-brasil-precisarao-de-licenca-previa-dos-eua-para-comprar-chips-de-ia.html
- Walsin MLCC export, 00_ALL_MLCC_parts_combined.xlsx, re-measured 17 November 2026; Venatech stock snapshot as at 9 November 2026.
Frequently asked questions
What does the new US AI-chip rule mean for data centres in Brazil?
O Povo reported on 16 November 2026 that a US Commerce rule requires licences for advanced AI chips going to certain data centres and lists Brazil among five higher-risk countries. It covers the chips, not passive components; confirm any export-control question with your compliance team.
What is a 0402 MLCC used for on a server board?
Mostly decoupling and bypass next to processor, memory, network and regulator power pins. The 0402 case is small enough to sit under a BGA and still holds 1 µF at low rail voltages, so one board can carry hundreds of them.
How many 1 µF 0402 MLCC does Walsin offer for designs in Brazil?
We counted 26 distinct Walsin part numbers at exactly 1 µF in 0402: 13 in X5R, 10 in X6S and 3 in X7R, rated from 6.3 V to 35 V. Venatech crosses and quotes them from Hong Kong for teams in Brazil.
Which Walsin part crosses a 1 µF 10 V 0402 X5R capacitor?
The closest standard match is 0402X105K100, which is on our shelf in Hong Kong (snapshot 9 Nov 2026). 0402X105K160 adds voltage headroom and 0402S105K100 moves to X6S for 105 °C. Confirm against both datasheets before release.
Should I choose X5R or X6S for a 0402 capacitor near a processor?
X5R is rated to 85 °C and X6S to 105 °C. If the capacitor sits near a hot processor or regulator in a dense rack, X6S gives more temperature margin; check DC bias and thickness on the datasheet as well.
Is Venatech an authorised Walsin distributor?
Yes. Venatech Limited is an authorised Walsin distributor in Hong Kong and serves teams in Brazil in small lots. Stackpole and Viking are lines we supply, not authorised lines.