NEWS

EV Charger Surge Protection in Malaysia: 7,341 Public Chargers, 2,349 of Them DC, and 47 Walsin MOV Varistors from 320 to 460 Vac

For EV charger surge protection in Malaysia, Walsin Technology (Walsin) lists 47 MOV varistors across the three rungs a charger input uses: 17 at 320 Vac, 17 at 420 Vac and 13 at 460 Vac, from 5 mm to 53 mm. Venatech, Walsin’s authorised distributor in Hong Kong, crosses your varistor and quotes the Walsin line.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for engineers in Malaysia who design, assemble or source AC wallboxes, DC fast chargers and the power modules inside them. Malaysia has both: a charging network that is still being built out, and EMS and power-electronics lines in Penang, Kulim and Johor that can build the hardware. We parsed Walsin’s varistor export, Venatech_MOV_Upload_01.xlsx (379 distinct part numbers), against Walsin’s MOV_catalog.pdf. The news figures name their source and date.

How many public EV chargers does Malaysia have in November 2026?

7,341 at the end of September. paultan.org reported on 16 November 2026 that Malaysia had 7,341 public EV chargers, 4,992 AC and 2,349 DC, citing Deputy Investment, Trade and Industry Minister Sim Tze Tzin in the Dewan Rakyat as reported by The Star.

The same report says the count was 6,416 about four months earlier, and that the national target is 30,000 public chargers by 2030, which puts the network at close to a quarter of the goal. We add no forecast. For a hardware engineer, two numbers matter: roughly 925 public chargers were added in four months, and about one charger in three is DC, the type that draws a three-phase supply and holds the most expensive power electronics. Both kinds need surge protection at the input, and the right varistor depends on which kind you build.

Why does EV charger surge protection need a varistor at the input?

Because outdoor equipment sees surges indoor kit never does. A metal-oxide varistor (MOV) clamps a lightning or switching surge before it reaches the rectifier and the power-factor stage; Walsin’s catalogue rates its 320 to 460 Vac parts from 400 A to 80,000 A peak current.

A charger sits in a car park, on a long cable from the distribution board, and often near overhead lines. The building’s surge protective device takes the first hit, but the charger still needs its own board-level clamp, because what passes the panel device can still destroy a PFC switch or a controller. In a DC charger the varistors usually sit across each phase pair or each phase to neutral, ahead of the EMI filter. Our guide on how to choose an MOV varistor covers the method, and the varistor range lists every part.

Which Walsin varistor voltages suit AC and DC chargers?

Three rungs on Walsin’s ladder. We counted 17 Walsin varistors at 320 Vac for a single-phase AC charger connected line to neutral, and 30 at 420 Vac or 460 Vac for a three-phase DC charger connected line to line: 47 part numbers in all.

Charger type and connection Walsin max working voltage Part numbers Sizes in the export
AC wallbox, line to neutral 320 Vac 17 5 to 53 mm
DC charger, line to line (tighter margin) 420 Vac 17 5 to 53 mm
DC charger, line to line (wider margin) 460 Vac 13 10 to 53 mm
Total 47

At each rung the parts come in four series: Standard D, High Energy E, Super High Energy V and Industrial. We checked all 13 parts at 460 Vac: that rung starts at 10 mm, with no 5 mm or 7 mm disc on that rung, so a compact auxiliary supply on a 460 Vac design moves to a 10 mm footprint. Our post on the MOV voltage ladder explains why the rungs sit where they do.

Which Walsin varistor fits a 460 Vac, 20 mm, 6,500 A charger brief?

Two parts match exactly. For a DC charger brief of 460 Vac maximum working voltage, a 20 mm disc and at least 6,500 A peak current, SR751K20D (6,500 A) and SR751K20E (13,000 A) both match; the Industrial SR751K32D matches with 30,000 A in a larger body.

Put your incumbent part in the last column and compare each field.

Walsin part Series Size Max working voltage Peak current Match / mismatch with 460 Vac, 20 mm, 6,500 A or more Your incumbent
SR751K20D Standard D 20 mm 460 Vac 6,500 A Match
SR751K20E Super High Energy V 20 mm 460 Vac 13,000 A Match, double the surge rating
SR751K25D Standard D 25 mm 460 Vac 18,000 A Match on rating; larger disc
SR751K32D Industrial 32 mm 460 Vac 30,000 A Match on rating; for the main input
SR751K14E Super High Energy V 14 mm 460 Vac 8,000 A Match on rating in a smaller disc
SR751K14D Standard D 14 mm 460 Vac 4,500 A Mismatch: surge rating below 6,500 A
SR681K20D Standard D 20 mm 420 Vac 6,500 A Mismatch on voltage; fits a 420 Vac brief
SR511K14D Standard D 14 mm 320 Vac 4,500 A Mismatch here; the AC wallbox part

SR751K14E is worth a look where board space is tight: it keeps the 14 mm footprint and still clears 6,500 A. Confirm clamping voltage and energy against both datasheets and qualify in your own circuit.

What should a charger engineer in Malaysia check between 420 Vac and 460 Vac?

The worst-case line-to-line voltage. On a 400 V class three-phase supply, a 10 percent high line reaches about 440 V between phases; a 420 Vac varistor then sits below the line, while a 460 Vac part keeps about 20 V of margin, at the cost of a higher clamping voltage.

Check the declared voltage and tolerance of the sites you sell into, not the nominal. A varistor that runs close to its maximum working voltage conducts a little on every cycle, heats and ages. A 460 Vac part such as SR751K20D tolerates a high line, but lets more voltage through to the bridge and the bulk capacitors, so check their ratings too. Pair each varistor with a thermal fuse or a fused design where your safety standard asks for it. We give no compliance advice on Malaysian charger rules; confirm those with your own team.

Can Venatech supply these varistors from Hong Kong?

Yes, to order. All 47 Walsin varistors on these three rungs can be quoted from Hong Kong: none is on our shelf in the snapshot dated 9 November 2026, so request a quote and we source them through our authorised Walsin channel.

Each quote states availability, date code and lead time for the line, and we work in small lots for prototypes, certification samples and pilot builds. We make no stock, price or lead-time promise. See the ready-stock list, a dated snapshot, for the capacitors and resistors that share the charger’s input board.

How Venatech helps: what should a Malaysian charger team send us?

The input-stage parts from your BOM. Venatech Limited, Walsin’s authorised distributor in Hong Kong, runs VenaMatch, which decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating every field where the Walsin part differs from your original.

Paste a varistor code into the cross-reference tool, or upload the whole BOM and request a quote through the site. The ready-stock snapshot is dated 9 November 2026. We serve Penang, Kulim, Johor and Selangor from Hong Kong, with fast quotes and small lots. Walsin is the line we are authorised for; Stackpole and Viking are lines we supply.

The short version

Malaysia had 7,341 public EV chargers at the end of September, 2,349 of them DC, paultan.org reported on 16 November 2026, against a target of 30,000 by 2030. Every charger needs a varistor at its input. Walsin covers the three rungs a charger uses with 47 parts: 17 at 320 Vac for AC wallboxes, and 30 at 420 or 460 Vac for three-phase DC units, where SR751K20D meets a 20 mm, 6,500 A brief exactly.

Send us your charger’s input protection parts and we will return Walsin crosses with every difference stated. Is your DC design rated for the high-line case at its worst site?

Related reading

Last reviewed: 17 November 2026.

Sources

Fetched 17 November 2026.

  • paultan.org, report on Malaysia’s public EV charger count (7,341 at end-September 2026), 16 November 2026: https://paultan.org/2026/11/16/malaysia-now-has-7341-public-ev-chargers-24-of-target/
  • Walsin varistor export, Venatech_MOV_Upload_01.xlsx, re-measured 17 November 2026; Walsin MOV_catalog.pdf; Venatech Hong Kong stock snapshot dated 9 November 2026.

Frequently asked questions

How many public EV chargers does Malaysia have?

paultan.org reported on 16 November 2026 that Malaysia had 7,341 public chargers at the end of September, 4,992 AC and 2,349 DC, against a target of 30,000 by 2030.

What varistor voltage suits a three-phase DC EV charger in Malaysia?

For a varistor connected line to line on a 400 V class supply, 460 Vac leaves margin over a high line of about 440 V. A 420 Vac part sits below that case, so check your worst-case site voltage first.

How many Walsin varistors suit EV charger inputs?

We counted 47 on the three rungs a charger uses: 17 at 320 Vac, 17 at 420 Vac and 13 at 460 Vac, from 5 mm to 53 mm.

Which Walsin part crosses a 20 mm 460 Vac varistor?

SR751K20D matches 460 Vac, 20 mm and 6,500 A, and SR751K20E keeps the size with 13,000 A. Confirm clamping voltage and energy against both datasheets before release.

What varistor suits a single-phase AC wallbox?

A 320 Vac part connected line to neutral is the usual choice, and Walsin lists 17 of them. SR511K14D is the 14 mm, 4,500 A option.

Can Venatech supply Walsin varistors to Malaysia from Hong Kong?

Yes. Venatech Limited is an authorised Walsin distributor in Hong Kong. Request a quote and we source them through our authorised Walsin channel, with availability, date code and lead time stated on each quote.


Share This, Choose Your Platform!