NEWS

0201 Thin Film Resistor for Aerospace Electronics in France: Airbus Delivers 621 Jets in 10 Months and 5,263 Walsin 0201 Thin Film Parts Cross Stackpole RNCF

A 0201 thin film resistor gives a dense avionics or sensor board precision in the smallest common chip. For France’s aerospace supply chain, Walsin lists 5,263 thin film parts in 0201, from 27 ohm to 12 kilohm at 0.1, 0.5 and 1 percent and 25 or 50 ppm, the smallest Stackpole RNCF size. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for hardware engineers and buyers at French makers of avionics, cabin electronics, sensors, test benches and aerospace subsystems. Walsin Technology (Walsin) is the line we are authorised for; Stackpole Electronics (SEI) is a line we supply, so an RNCF already on your parts list can be quoted as it is or crossed to Walsin. We measured every Walsin figure below on 17 November 2026 in our Walsin export Thin_Film_Precision_Chip_Resistor_WF_Series_0201_060.xlsx, counting distinct part numbers, and checked our ready stock snapshot dated 9 November 2026. Stackpole figures come only from Stackpole’s resistors-for-medical-applications release of 2 May 2019 on seielect.com, fetched on 17 November 2026; the RNCF datasheet on seielect.com did not load for us that day, so confirm each Stackpole figure against it.

How many aircraft has Airbus delivered in 2026 so far?

621 by the end of October. AirData News reported on 6 November 2026 that Airbus delivered 74 aircraft to 45 customers in October 2026, taking deliveries for January to October to 621, up 6.2 percent on the 585 of the same period in 2025, against a full-year goal of about 870.

The same report counted 202 gross orders in October and noted that Airbus needs 249 more deliveries in November and December to reach its goal. Those are the publication’s figures, not ours. Airbus’s commercial aircraft business is centred on Toulouse, and French makers of flight control, cabin, sensor and test electronics feed programmes like these. A delivery rate in the seventies a month means steady board builds, and those boards are where small precision resistors live.

Where does a 0201 thin film resistor earn its place on an aerospace board?

Where precision and space are both scarce. A 0201 thin film resistor sets gain, divider ratios, sensor bridges and reference networks on boards too dense for 0402; thin film gives tighter tolerance and lower TCR than thick film at the same size, at a much smaller power rating.

Typical places are sensor front ends in a probe or actuator, ADC reference dividers, filter networks in a cabin system, and modules where weight and area count. The constraint is power: at 0201, Walsin’s export lists 1/20 W and 1/32 W, so the part belongs in signal positions, not in a supply or pull-down that carries current. Stackpole’s release of 2 May 2019 places RNCF in the same role for small medical sensors, describing it as a precision chip with small size, a wide value range and a range of TCR and tolerance options, used in 0201 to 0603. Our thin film by case size note shows how the range changes as the chip grows.

How many Walsin 0201 thin film resistors are there?

5,263. We counted 5,263 distinct Walsin WF series part numbers in 0201 in our export, at 547 resistance values from 27 ohm to 12 kilohm; 1,431 are 0.1 percent, 1,916 are 0.5 percent and 1,916 are 1 percent.

0201 grade in the export Parts Resistance span TCR classes Example at 10 kilohm
0.1 percent 1,431 100 ohm to 12 kilohm 25 and 50 ppm WF02Q1002BTL
0.5 percent 1,916 27 ohm to 12 kilohm 25 and 50 ppm WF02Q1002DTL
1 percent 1,916 27 ohm to 12 kilohm 25 and 50 ppm WF02Q1002FTL

By TCR, 2,921 parts are 25 ppm and 2,342 are 50 ppm; by power, 2,707 are 1/20 W and 2,556 are 1/32 W. The point we have not seen made elsewhere: at 0201, Walsin offers the 25 ppm class at both power ratings, so WF02Q1002BTL at 1/20 W and WF02U1002BTL at 1/32 W share value, 0.1 percent tolerance and 25 ppm, and differ only in the fifth character and the power rating. Pick the Q code if a position needs the extra headroom.

Which Walsin parts cross a Stackpole RNCF thin film resistor in 0201?

On size, value, tolerance and TCR, once you state the grade. Stackpole’s release gives RNCF sizes from 0201 to 0603 and a range of tolerance and TCR options without listing them, so the cross starts from your RNCF grade; Walsin covers 0.1, 0.5 and 1 percent at 25 or 50 ppm in 0201.

Your brief (RNCF0201 style) Walsin part Walsin size, power, TCR (export) Match / mismatch Your incumbent
10 kilohm, 0.1 percent, 25 ppm WF02Q1002BTL 0201, 1/20 W, 25 ppm Match on size, value, tolerance, TCR
10 kilohm, 0.1 percent, 25 ppm, lowest power WF02U1002BTL 0201, 1/32 W, 25 ppm Match on size, value, tolerance, TCR; check power headroom
4.99 kilohm, 0.5 percent, 25 ppm WF02Q4991DTL 0201, 1/20 W, 25 ppm Match on size, value, tolerance, TCR
10 kilohm, 1 percent, 50 ppm WF02T1002FTL 0201, 1/32 W, 50 ppm Match on size, value, tolerance, TCR
10 ppm or tighter, or 0.05 percent none in 0201 25 ppm and 0.1 percent are the floors in our export Mismatch: move to 0402 or keep the incumbent

What should a French aerospace electronics team check before switching?

Qualification first, then stability and power. Check what your programme’s qualification and change control demand before any cross, then compare long-term drift, moisture and temperature-cycling data, and confirm the 1/20 W or 1/32 W rating against your worst-case dissipation.

A resistor change on a flight or cabin board is a configuration change, so it runs through your quality system, not through purchasing alone. Walsin’s thin film datasheets are commercial and industrial documents; we make no aerospace qualification claim for them and give no certification or compliance advice, so confirm with your compliance team. On the engineering side, 25 ppm over a 125 degree span is a 0.31 percent shift, which may matter more than the 0.1 percent tolerance in a bridge or reference. Where the board allows a 0402, our precision thin film tolerance and TCR note shows the tighter grades available there, and thin film versus thick film covers the basics.

How Venatech helps

Cross the precision lines in one paste. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating size, value, tolerance, TCR and power as match or mismatch.

Paste your resistor lines into the cross-reference tool, or upload the parts list at BOM upload. On our shelf in Hong Kong (snapshot 9 Nov 2026) are two Walsin 0402 thin film lines, WF04H1202DTL and WF04H3302DTL, at 12 and 33 kilohm with the D tolerance code for 0.5 percent; check their TCR on Walsin’s datasheet, and see ready stock. The 0201 parts above are not on it, so request a quote and we source them through our authorised Walsin channel. Stackpole RNCF lines can be quoted too; Stackpole is a line we supply, and Walsin is the line we are authorised for. We serve French buyers from Hong Kong in small lots and confirm availability, date code and lead time on each quote, with no price, lead-time or stock guarantee. The chip resistor range lists every Walsin family.

The short version

  • Airbus delivered 621 aircraft from January to October 2026, per AirData News on 6 November 2026.
  • Walsin lists 5,263 thin film parts in 0201 from 27 ohm to 12 kilohm; 1,431 are 0.1 percent.
  • The 25 ppm class comes at both 1/20 W and 1/32 W in 0201; the Q and U codes differ only in power.
  • Stackpole RNCF crosses on size, value, tolerance and TCR once you state its grade; qualification decides the rest.

Send us the precision resistor lines from your board, and we will return the Walsin crosses with every difference stated. Which position on your board sets the accuracy budget?

Related reading

Last reviewed: 17 November 2026.

Sources

Fetched 17 November 2026.

  • AirData News, “Airbus delivers 74 aircraft in October, needs 249 more to meet 2026 target”, 6 November 2026: https://www.airdatanews.com/airbus-delivers-74-aircraft-in-october-needs-249-more-to-meet-2026-target/
  • Stackpole Electronics release on resistors for medical applications, 2 May 2019: https://seielect.com/news/20190502_Resistors_for_Medical_Applications.pdf
  • Venatech Walsin thin film export (Thin_Film_Precision_Chip_Resistor_WF_Series_0201_060.xlsx) and ready stock snapshot dated 9 November 2026, re-measured 17 November 2026.

Frequently asked questions

What 0201 thin film resistor grades does Walsin offer for aerospace boards in France?

In our export, 0.1, 0.5 and 1 percent at 25 or 50 ppm, from 27 ohm to 12 kilohm, at 1/20 W or 1/32 W: 5,263 distinct part numbers in all.

How many Walsin 0201 thin film parts are 0.1 percent?

1,431, from 100 ohm to 12 kilohm, at 25 or 50 ppm. Below 100 ohm, the 0201 range starts at 0.5 percent.

Which Walsin part crosses a Stackpole RNCF0201 at 10 kilohm, 0.1 percent, 25 ppm?

WF02Q1002BTL, a 0201, 10 kilohm, 0.1 percent, 25 ppm, 1/20 W part in our export, or WF02U1002BTL at 1/32 W. Confirm the grade on your RNCF datasheet first.

Is there a 10 ppm Walsin thin film resistor in 0201?

Not in our export: 25 ppm is the tightest TCR class in 0201. For 10 ppm or tighter, move the position to 0402 or larger.

Are Walsin thin film resistors qualified for aerospace?

We make no aerospace qualification claim for them. Walsin’s datasheets are commercial and industrial documents; run any change through your programme’s qualification and change control, and confirm with your compliance team.

Is Venatech authorised for Stackpole?

No. Venatech is the authorised Walsin distributor in Hong Kong; Stackpole is a line we supply, and we quote Stackpole RNCF lines alongside the Walsin cross.


Share This, Choose Your Platform!