NEWS

AEC-Q200 MLCC for Engine Control Units in Italy: Stellantis Reports ECU Component Disruption at Fiat Plants, and Walsin Lists 2,283 Automotive-Qualified Capacitors

Stellantis said on 2 November 2026 that a shortage of one electronic component used in an engine control unit was disrupting some Fiat production in Italy. When one ECU line wobbles, buyers review every second source. Walsin Technology (Walsin) lists 2,283 AEC-Q200 MLCC. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for automotive electronics engineers, and the buyers who support them, at ECU makers, tier-1 suppliers and EMS lines in Italy. The Stellantis report concerns one electronic component from one chip supplier, which the reports do not name; it is not about capacitors, and we make no claim about any supplier, model or bill of materials. What it does do is put second sourcing back on the agenda for every line on an engine-control board. On 18 November 2026 we re-measured Walsin’s MLCC export (Venatech_MLCC_Upload_01.xlsx to Venatech_MLCC_Upload_08.xlsx, 23,360 part numbers) for every part in its AEC-Q200 series.

What did Stellantis say about Fiat production in Italy?

That one ECU component was short. Reuters, as published by The Star on 2 November 2026, reported that Stellantis said a shortage of an electronic component used in an engine control unit was causing significant disruption to production of some Fiat models in Italy, and could continue through November and December.

The same report names the Pomigliano plant, which builds the Pandina, and Mirafiori, which builds the Fiat 500, as sites where production halts are possible, and says the Termoli engine plant could also be affected. Stellantis and Fiat are working on alternative solutions, Reuters wrote. Silicon UK added on 3 November 2026 that Mirafiori had already been halted for three weeks from mid-October over a separate component shortage. Neither report names the component maker, and neither mentions passive components. We draw no conclusion about passives supply from either report.

What should an ECU engineer in Italy check when one component is disrupted?

Every single-source line, not only the one that failed. An engine control unit carries dozens to hundreds of passive positions, and a review after a disruption usually starts with three checks per line: a qualified second source, matching AEC-Q200 status, and documentation that a PPAP or change process will accept.

For a capacitor, the second source has to match more than value and voltage. Case size, dielectric, tolerance and thickness decide whether it is a drop-in match, and the qualification status decides whether it can go on the board without a new approval. Walsin separates its automotive MLCC into two families, MT (qualified to AEC-Q200) and MG (automotive, without AEC-Q200 certification); the difference matters for an ECU. Our note on AEC-Q200 MLCC, MT vs MG explains the split, and what AEC-Q200 actually certifies covers what the qualification does and does not prove.

How many Walsin AEC-Q200 MLCC are there?

Two thousand two hundred and eighty-three. We parsed all 23,360 rows of Walsin’s MLCC export and counted 2,283 distinct part numbers in its AEC-Q200 series: 2,167 in MT and 116 in the soft-termination ST series, from 0201 to 2220.

Cut of the AEC-Q200 range Part numbers
C0G (NP0) 1,287
X7R 993
X8G 3
0402 486
0603 615
0805 532
1206 338
At 100 nF, all sizes 58
Total, MT plus ST 2,283

A further 783 part numbers sit in the MG family, which is automotive grade without AEC-Q200 certification, and we leave those out of every count above. Check the datasheet for each series, MT, ST or MG, before you approve a part: the qualification statement and the temperature range come from the datasheet, not from a part number. The MLCC range page links them.

Does a general-purpose 100 nF capacitor have an AEC-Q200 twin?

Usually yes. We matched each MLCC on our shelf to Walsin’s AEC-Q200 series by size, dielectric, capacitance, voltage and tolerance: 322 of the 750 stocked MLCC part numbers have an exact MT or ST twin.

That matters when a prototype was built with general-purpose parts and the production board needs AEC-Q200. The table shows the common 100 nF X7R decoupling position. The match column assumes a 100 nF X7R brief at the same case, voltage and tolerance as the shelf part.

Shelf part (general purpose) Case Voltage Tolerance AEC-Q200 twin Match / mismatch Your incumbent
0603B104K500 0603 50 V ±10 % MT18B104K500, ST18B104K500 Match, MT or soft-term ST
0603B104K250 0603 25 V ±10 % MT18B104K250, ST18B104K250 Match
0603B104K101 0603 100 V ±10 % MT18B104K101, ST18B104K101 Match
0402B104K500 0402 50 V ±10 % MT15B104K500 Match
0805B104K101 0805 100 V ±10 % MT21B104K101, ST21B104K101 Match
0805B104K500 0805 50 V ±10 % MT21B104J500 (±5 %) Mismatch on tolerance only; tighter is usually acceptable
0402X104K160 0402 16 V ±10 % MT15B104K160 is X7R Mismatch on dielectric; X7R is the better grade

Have part numbers to quote? Click any Walsin part number in the table to open its page and add it to your RFQ, or upload your BOM for a quote, or cross your current part in VenaMatch. E-mail sales@venatech.com.hk or call (852) 2628 4777. We confirm availability, date code and lead time on each quote.

Put your incumbent in the last column and compare both datasheets, including thickness, before you raise a change. A twin on paper still goes through your own qualification and customer approval process.

Which of these capacitors are on the shelf in Hong Kong?

The general-purpose parts are. We checked all 2,283 AEC-Q200 part numbers against our ready-stock snapshot dated 9 November 2026; the AEC-Q200 parts are supplied to order, while their general-purpose twins, such as 0603B104K500 and 0805B104K101, are on our shelf in Hong Kong.

On our shelf in Hong Kong (snapshot 9 November 2026) means held on that date; it is not a promise of quantity or date code today. For the MT and ST parts, request a quote and we source them through our authorised Walsin channel, confirming availability, date code and lead time on each quote. Use the general-purpose shelf parts for prototypes and bench work only where your process allows it; production ECU boards should carry the qualified part your approval names.

How Venatech helps

How Venatech helps is a checked cross before the next build. Venatech Limited, Walsin’s authorised distributor in Hong Kong, runs VenaMatch, which decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, so an ECU capacitor list returns Walsin candidates with AEC-Q200 status, size and voltage stated.

Paste your capacitor part numbers into the cross-reference tool, or upload the whole ECU BOM and request a quote through the site. The ready-stock snapshot, dated 9 November 2026, lists what is on our shelf in Hong Kong. We are Hong Kong-based, serve buyers in Italy in small lots, and confirm availability, date code and lead time on every quote. Walsin is our authorised line; Stackpole and Viking are lines we supply. For approval rules in your customer contracts, confirm with your quality and compliance teams.

The short version

Stellantis reported on 2 November 2026 that a shortage of one ECU component was disrupting some Fiat production in Italy, with possible halts at Pomigliano and Mirafiori into December. The lesson for ECU teams is to check every single-source line. Walsin lists 2,283 AEC-Q200 MLCC, 58 of them at 100 nF, and 322 of the 750 MLCC lines on our shelf in Hong Kong have an exact AEC-Q200 twin.

Send us the capacitor lines from your ECU board, and we will return Walsin AEC-Q200 crosses with every difference stated. Which capacitor on that board has a single source today?

Related reading

Last reviewed: 18 November 2026

Sources

Fetched 18 November 2026.

  • The Star (Reuters), “Stellantis chip shortage disrupts Fiat output in Italy, may last through December”, 2 November 2026: https://www.thestar.com.my/tech/tech-news/2026/11/02/stellantis-chip-shortage-disrupts-fiat-output-in-italy-may-last-through-december
  • Silicon UK, “Stellantis Warns Of Production Delays Amid Chip Shortage”, 3 November 2026: https://www.silicon.co.uk/workspace/components/stellantis-chip-shortage-632146
  • Walsin MLCC export, Venatech_MLCC_Upload_01.xlsx to Venatech_MLCC_Upload_08.xlsx, re-measured 18 November 2026; Venatech ready-stock snapshot dated 9 November 2026.

Frequently asked questions

Which Fiat plants in Italy did Stellantis say could be affected?

Reuters reported on 2 November 2026 that halts were possible at Pomigliano and Mirafiori in November and December, and that the Termoli engine plant could also be affected. The component maker was not named.

Was the Stellantis ECU shortage about capacitors?

The reports describe an electronic component used in an engine control unit, from a chip supplier. They do not mention capacitors or other passives, and we draw no conclusion about passives supply.

How many AEC-Q200 MLCC does Walsin list?

We counted 2,283 distinct part numbers: 2,167 in the MT series and 116 in the soft-termination ST series, from 0201 to 2220.

What is the difference between Walsin MT and MG automotive MLCC?

MT is qualified to AEC-Q200; MG is automotive grade without AEC-Q200 certification. Walsin lists 783 MG part numbers. Check the datasheet before approving either for an ECU.

Can I swap a general-purpose MLCC for an AEC-Q200 one in Italy?

Often by part number: 322 of the 750 MLCC lines on our shelf in Hong Kong have an exact MT or ST twin. The swap still goes through your own qualification and customer approval.

Is Venatech an authorised Walsin distributor for buyers in Italy?

Venatech Limited is an authorised Walsin distributor in Hong Kong and serves buyers in Italy in small lots. Stackpole and Viking are lines we supply, not authorised lines.


Share This, Choose Your Platform!