For an AEC-Q200 MLCC on cockpit electronics built in Spain, Walsin Technology (Walsin) lists 2,167 MT-series automotive capacitors from 0201 to 1210, including 26 parts at 1 uF. Venatech Limited, an authorised Walsin distributor in Hong Kong, crosses your current part to the MT series and quotes it.
Venatech wrote this for hardware and purchasing engineers in Spain who build or source automotive displays, cockpit domain controllers and the boards around them. We parsed Walsin’s MLCC exports (Venatech_MLCC_Upload_01.xlsx to Venatech_MLCC_Upload_07.xlsx, 23,360 distinct part numbers) and read the MT rows against Walsin’s WTC_MLCC_Automotive_MT.pdf datasheet. The news figure carries its source and date.
What did Desay SV open in Linares, Spain?
A smart manufacturing plant for automotive displays and cockpit domain controllers. Desay SV said on 12 November 2026 that its Linares facility in Spain has about 20,000 square metres of built-up area and a maximum designed output of 2.8 million units a year once all phases are complete.
According to the same release, mass production is expected to start in the first quarter of 2027, the site will create up to 500 direct jobs by 2030, and Desay SV Spain has received formal project nominations from two international automakers it did not name. We add no forecast and make no statement about the company’s suppliers. For an engineer in Spain, the point is simpler: a new high-volume cockpit electronics line in Andalusia means more boards that must carry automotive-grade passives, and more NPI teams checking that every capacitor on the BOM has AEC-Q200 documentation behind it.
Which AEC-Q200 MLCC does a cockpit domain controller use?
Mostly X7R decoupling and bulk parts plus C0G timing and filter parts. A cockpit domain controller typically carries hundreds of MLCC, most of them 100 nF to 10 uF X7R parts in 0402 to 0805 for SoC, memory and PMIC rails, with C0G parts in the pF to nF range for clocks, filters and display interfaces.
The board sits behind the dashboard, so it sees cabin temperature swings, vibration and long service life. That is why automotive programmes ask for AEC-Q200 qualified MLCC and an operating range of at least -55 to +125 °C. Display boards add LED backlight drivers and timing controllers, which bring more 0402 and 0603 decoupling and a few higher-voltage parts on the backlight boost stage. Our guide to the MT and MG automotive MLCC series explains how Walsin separates qualified and non-qualified automotive parts, and the full MLCC range lists every series.
How many AEC-Q200 MLCC does Walsin list, and in which sizes?
Two thousand one hundred and sixty-seven. We counted 2,167 distinct part numbers in Walsin’s “Automotive Caps Qualified to AEC-Q200 (MT series)” group: 1,284 are C0G/NP0, 880 are X7R and 3 are X8G, and every row we checked is rated -55 to +125 °C.
| Case size | MT-series parts | Typical cockpit use |
|---|---|---|
| 0201 | 204 | Dense SoC escape decoupling, RF |
| 0402 | 485 | SoC, memory and PMIC decoupling |
| 0603 | 581 | General decoupling, filters, timing |
| 0805 | 508 | 1 uF bulk, input filters |
| 1206 | 311 | Higher voltage, larger values |
| 1210 | 78 | Bulk up to 10 uF |
| Total | 2,167 |
We also measured 44 MT parts at 100 nF and 26 at 1 uF. The ST series adds 116 AEC-Q200 soft-termination parts for boards that flex, and the MG series covers automotive parts without AEC-Q200 certification; we keep those apart because a programme that asks for AEC-Q200 needs the MT or ST code.
Which Walsin part fits a 1 uF, 16 V, X7R automotive brief?
Five MT parts meet it in 0603 or 0805. For a brief of 1 uF, X7R, ±10 percent, at least 16 V, AEC-Q200, in 0603 or 0805, MT18B105K160 matches in 0603, and MT21B105K160, MT21B105K250 and MT21B105K500 match in 0805 with more voltage headroom.
Put your incumbent part in the last column and compare each field.
| Walsin part | Size | Capacitance | Dielectric | Tolerance | Rated voltage | Match / mismatch with 1 uF, X7R, ±10%, 16 V or more, 0603/0805 | Your incumbent |
|---|---|---|---|---|---|---|---|
MT18B105K160 |
0603 | 1 uF | X7R | ±10% | 16 V | Match | |
MT18B105J160 |
0603 | 1 uF | X7R | ±5% | 16 V | Match, tighter tolerance | |
MT21B105K160 |
0805 | 1 uF | X7R | ±10% | 16 V | Match | |
MT21B105K250 |
0805 | 1 uF | X7R | ±10% | 25 V | Match, 9 V more headroom | |
MT21B105K500 |
0805 | 1 uF | X7R | ±10% | 50 V | Match, suits a 12 V battery-fed rail | |
MT21B105K100 |
0805 | 1 uF | X7R | ±10% | 10 V | Mismatch: voltage below 16 V | |
MT31B105K250 |
1206 | 1 uF | X7R | ±10% | 25 V | Mismatch on size; fits a 1206 footprint |
Have part numbers to quote? Click any Walsin part number in the table to open its page and add it to your RFQ, or upload your BOM for a quote, or cross your current part in VenaMatch. E-mail sales@venatech.com.hk or call (852) 2628 4777. We confirm availability, date code and lead time on each quote.
Check the thickness column on the datasheet before you swap 0603 for 0805 or the reverse, and confirm the part against your own qualification plan.
Why does voltage headroom matter for an automotive 1 uF MLCC?
Because X7R capacitance falls as DC voltage rises. An X7R MLCC run at a large share of its rated voltage can lose a substantial part of its nominal capacitance, so a 1 uF part on a 12 V rail is often specified at 25 V or 50 V rather than 16 V.
The loss depends on the case size, the dielectric thickness and the bias, which is why a larger case or a higher rated voltage usually keeps more of the nominal value. Cockpit boards add a second reason: a rail tied to the vehicle battery sees load-dump and cold-crank transients, so many teams set a voltage floor well above the nominal rail. Our note on MLCC DC bias and voltage derating covers the method.
Check the datasheet. The DC-bias curves, thickness per case and AEC-Q200 test conditions for the MT series are on Walsin’s WTC_MLCC_Automotive_MT.pdf datasheet, not in the export, so take them from there before release.
Can Venatech supply Walsin AEC-Q200 MLCC to Spain?
Yes, to order. All 2,167 MT-series parts can be quoted from Hong Kong; none is on our shelf in Hong Kong (snapshot 9 Nov 2026), so request a quote and we source them through our authorised Walsin channel.
Each quote states availability, date code and lead time, and we work in small lots for prototypes, pilot builds and qualification samples. We make no stock, price or lead-time promise. The same snapshot does hold 750 Walsin MLCC lines that we matched to the export, useful for non-automotive boards and test fixtures.
How Venatech helps
Send us the capacitor lines from your cockpit or display BOM. Venatech Limited, Walsin’s authorised distributor in Hong Kong, runs VenaMatch, which decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, stating every field where the Walsin part differs from yours.
Paste a part into the cross-reference tool, upload the whole BOM, and request a quote through the site. The ready-stock list is a dated snapshot (9 November 2026). We serve Spain from Hong Kong with fast quotes and small lots. Walsin is the line we are authorised for.
The short version
Desay SV opened its Linares plant on 12 November 2026, designed for up to 2.8 million automotive displays and cockpit domain controllers a year, with mass production expected in the first quarter of 2027. Those boards need AEC-Q200 MLCC. Walsin covers the job with 2,167 MT-series parts from 0201 to 1210, and MT21B105K250 meets a 1 uF, X7R, 16 V-or-more brief in 0805 with headroom to spare.
Send us the MLCC lines from your cockpit board and we will return MT-series crosses with every difference stated. Which rail on your board runs closest to its capacitor’s rated voltage?
Related reading
- AEC-Q200 MLCC: MT vs MG series
- MLCC DC bias and voltage derating
- NP0 vs X7R vs X5R MLCC dielectric
- Cross-reference tool, BOM upload and ready-stock snapshot
Last reviewed: 19 November 2026.
Sources
Fetched 19 November 2026.
- Desay SV via PR Newswire, “Desay SV Opens Smart Manufacturing Facility in Linares, Spain”, 12 November 2026: https://www.prnewswire.com/apac/news-releases/desay-sv-opens-smart-manufacturing-facility-in-linares-spain-strengthening-its-european-presence-302937044.html
- Walsin MLCC exports, Venatech_MLCC_Upload_01.xlsx to Venatech_MLCC_Upload_07.xlsx, re-measured 19 November 2026; Walsin WTC_MLCC_Automotive_MT.pdf datasheet; Venatech Hong Kong stock snapshot dated 9 November 2026.
Frequently asked questions
What did Desay SV open in Linares, Spain?
On 12 November 2026 Desay SV opened a plant in Linares of about 20,000 square metres for automotive displays and smart cockpit domain controllers, designed for up to 2.8 million units a year. Mass production is expected in the first quarter of 2027.
What is an AEC-Q200 MLCC?
It is a multilayer ceramic capacitor qualified to the AEC-Q200 stress tests for automotive passive components. Walsin’s qualified range is the MT series, with the ST series for soft-termination parts.
How many AEC-Q200 MLCC does Walsin list?
We counted 2,167 MT-series part numbers from 0201 to 1210: 1,284 C0G/NP0, 880 X7R and 3 X8G, all rated -55 to +125 °C.
Which Walsin part crosses a 1 uF 16 V X7R automotive MLCC in 0805?
MT21B105K160 matches at 16 V, and MT21B105K250 and MT21B105K500 match with more voltage headroom. In 0603, MT18B105K160 matches.
Why specify a 25 V or 50 V MLCC on a 12 V automotive rail?
X7R capacitance falls under DC bias, and battery-fed rails see transients. A higher rated voltage keeps more of the nominal capacitance and adds margin.
Can Venatech supply Walsin AEC-Q200 MLCC to Spain from Hong Kong?
Yes. Venatech Limited is an authorised Walsin distributor in Hong Kong. Request a quote and we source the parts through our authorised Walsin channel, with availability, date code and lead time stated on each quote.