NEWS

0.1% Resistor at 25 ppm for Yokneam, Israel: 1,029 Walsin Parts for Chip-Design and Medical Boards

A 0.1% resistor at 25 ppm/°C holds a gain, divider or reference ratio tight enough for test, measurement and medical front ends. Walsin lists 1,029 thick film parts at 0.1% and 25 ppm, 343 values each in 0603, 0805 and 1206, from 470 ohm to 470 kilohm. Venatech is the authorised Walsin distributor in Hong Kong.


Venatech Limited, an authorised Walsin distributor in Hong Kong, wrote this for hardware, analog and validation engineers and buyers in Yokneam, the Haifa area and across Israel, where chip-design, networking and medical-device teams build boards that need precise ratios. Walsin Technology (Walsin) is the line we are authorised for. We parsed all 79 chip resistor upload files, Venatech_ChipR_Upload_01.xlsx to Venatech_ChipR_Upload_79.xlsx, on 16 November 2026, kept the high precision thick film series and counted distinct part numbers by tolerance and TCR. Every part number below is real.

What is Nvidia building in Yokneam in 2026?

An 11-storey office tower beside its two existing Yokneam buildings. Ynetnews reported on 10 May 2026 that BST Group will build a new tower for Nvidia at the Ofer Yokneam park, about 43,000 square metres in all with about 29,000 square metres of offices, in a project of about 170 million shekels.

According to the report, site work was due to start on 1 May 2026 with about 25 months of construction, partial delivery in September 2027 and full occupancy in May 2028. Those are the publication’s figures, not ours. A building of that size is a statement about engineering headcount in Yokneam, and engineering sites of this kind run hardware labs: evaluation boards, test fixtures, power and signal validation rigs. Those boards, like the instruments built by Israel’s medical-device makers, are where a precision ratio resistor matters.

Where does a 0.1% resistor earn its place on a validation or medical board?

Wherever a ratio sets an accuracy the system cannot calibrate out. A divider built from two 0.1% resistors keeps its ratio within roughly 0.2 percent at worst, and two 25 ppm/°C parts drift apart by at most 50 ppm per degree, so a 20 °C swing moves the ratio by no more than about 0.1 percent.

Typical places are ADC and DAC reference dividers, instrumentation-amplifier gain resistors, current-sense amplifier gain networks, voltage monitors on power rails under test, and the analog front end of patient-monitoring or diagnostic instruments. Tolerance sets the error you start with; TCR sets how far it moves as the board warms. On many boards the second matters more, because a one-off offset can be trimmed in firmware while a temperature drift cannot. Our posts on what resistor TCR actually buys you and tolerance, TCR and dielectric codes decoded explain the codes.

How many 0.1% resistors at 25 ppm does Walsin list?

1,029. We counted 16,103 Walsin thick film part numbers at 0.1% tolerance; 1,029 of them carry the 25 ppm/°C TCR, all in the TC25 series, split evenly at 343 values in each of 0603, 0805 and 1206, from 470 ohm to 470 kilohm.

TCR at 0.1% tolerance Walsin parts Sizes
25 ppm/°C (TC25) 1,029 0603, 0805, 1206
50 ppm/°C (TC50, incl. automotive) 4,340 0402 to 1206
100 ppm/°C (TC100) 9,587 0402 to 2512
200 ppm/°C 1,142 0201
Other 5 0402 to 1210

The 25 ppm parts are rated 1/10 W in 0603, 1/8 W in 0805 and 1/4 W in 1206, and the common reference values, 1 kilohm, 4.99 kilohm, 10 kilohm, 49.9 kilohm and 100 kilohm, exist in all three sizes. We have not seen this 0.1% split by TCR counted anywhere else.

Which Walsin parts cross a 10 kilohm, 0.1%, 25 ppm, 0603 brief?

One part matches in 0603, and two more match in larger bodies. At 10 kilohm, 0.1% and 25 ppm, Walsin offers WF06J1002BTL in 0603, WF08J1002BTL in 0805 and WF12J1002BTL in 1206; the TC50, TC100 and anti-sulfur parts at the same value match on tolerance but not on TCR.

Brief: 10 kilohm, 0.1%, 25 ppm, 0603 Walsin part TCR Match / mismatch Your incumbent
Direct fit WF06J1002BTL 25 ppm Match
Larger body, more power WF08J1002BTL 25 ppm Mismatch in size (0805)
1206 body, 1/4 W WF12J1002BTL 25 ppm Mismatch in size (1206)
TC50 WF06K1002BTL 50 ppm Mismatch in TCR
TC50, AEC-Q200 WF06K1002BTLJ 50 ppm Mismatch in TCR; adds AEC-Q200
TC100 WF06H1002BTL 100 ppm Mismatch in TCR
Anti-sulfur precision SF06H1002BTL 100 ppm Mismatch in TCR; adds anti-sulfur

Leave the last column for your current part and confirm both datasheets, as set out in cross-referencing chip resistors to Walsin. On our shelf in Hong Kong (snapshot 9 Nov 2026) are three Walsin 0.1% TC100 lines, WF08H8203BTL at 820 kilohm, WF12H1202BTL at 12 kilohm and WF12H5762BTL at 57.6 kilohm; the TC25 parts are to order through our authorised Walsin channel.

When should a Yokneam team move from a 0.1% thick film resistor to thin film?

When the brief goes tighter than 0.1% and 25 ppm, or below 470 ohm or above 470 kilohm at that grade. Walsin’s TC25 thick film covers 470 ohm to 470 kilohm at 0.1% and 25 ppm; for a tighter tolerance, a lower TCR or ratio-matched networks, Walsin’s thin film line is the next step.

Thin film also brings lower current noise and better long-term stability, which matter in low-level medical and measurement front ends. The trade is that much of a thin film matrix is made to order. Our comparison of high precision thick film against thin film and the thin film range show where each fits, and the chip resistor range lists every thick film series.

How Venatech helps: what can we cross for a Yokneam hardware lab?

Every precision line on the board, crossed field by field. Venatech is the authorised Walsin distributor in Hong Kong; VenaMatch decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, including all 1,029 TC25 parts in this post.

Paste your gain and divider resistors into the cross-reference tool, upload a BOM at /bom/, or check the dated ready stock list. We serve Israel from Hong Kong in small lots, which suits evaluation and validation builds, and we quote fast. We confirm availability, date code and lead time on each quote and promise none in advance; import questions stay with your compliance team.

The short version

  • BST Group is building an 11-storey, about 43,000 square metre Nvidia tower in Yokneam, with full occupancy planned for May 2028 (Ynetnews, 10 May 2026).
  • Walsin lists 16,103 thick film resistors at 0.1%; 1,029 of them are 25 ppm, all in the TC25 series.
  • The TC25 parts come in 0603, 0805 and 1206, 343 values each, from 470 ohm to 470 kilohm.
  • Three Walsin 0.1% lines are on our shelf in Hong Kong (snapshot 9 Nov 2026).

Send us the precision resistors from your next evaluation board and we will return the Walsin crosses with every difference stated. Is it the tolerance or the drift that sets your error budget?

Related reading

Last reviewed: 16 November 2026.

Sources

Fetched 16 November 2026.

  • Ynetnews, BST Group to build new Nvidia office tower in Yokneam in NIS 170 million project, 10 May 2026: https://www.ynetnews.com/business/article/bysrjttaze
  • Venatech chip resistor upload files Venatech_ChipR_Upload_01.xlsx to _79.xlsx and Walsin datasheets ASC_WFxxJ.pdf, ASC_WFxxK_J_AUTO.pdf and ASC_SFxxH.pdf as linked in the export, re-measured 16 November 2026; Venatech ready stock snapshot dated 9 November 2026.

Frequently asked questions

How many 0.1% resistors at 25 ppm does Walsin make?

1,029 in our count of 16 November 2026, all in the TC25 thick film series: 343 values each in 0603, 0805 and 1206, from 470 ohm to 470 kilohm.

Which Walsin part is a 10k 0.1% 25 ppm 0603 resistor?

WF06J1002BTL. The same value at the same grade is WF08J1002BTL in 0805 and WF12J1002BTL in 1206. Confirm footprint and power against both datasheets.

Is a 0.1% thick film resistor good enough for a medical front end?

Often for gain and reference dividers, if 25 ppm drift fits your error budget. For tighter tolerance, lower TCR or low noise, look at thin film, and qualify the part in your own design.

What is the difference between Walsin TC25, TC50 and TC100?

The TCR: 25, 50 and 100 ppm per degree Celsius. At 0.1% tolerance Walsin lists 1,029 TC25, 4,340 TC50 and 9,587 TC100 parts.

Does Venatech stock 0.1% resistors for Israel?

We hold stock in Hong Kong. Three Walsin 0.1% TC100 lines are on our shelf in Hong Kong (snapshot 9 Nov 2026); TC25 parts are quoted through our authorised Walsin channel.

Can Venatech supply hardware teams in Yokneam, Israel?

Yes. Venatech is the authorised Walsin distributor in Hong Kong and quotes small lots to Israel. Use the cross-reference tool or upload a BOM; confirm import rules with your compliance team.


Share This, Choose Your Platform!