NEWS

DC Blocking Capacitor for Photonic Chip Boards in the Netherlands: the EU Puts 400 Million Euros into PIX Europe, and 72 Walsin 100 nF Parts in 0201 and 0402

The EU has committed 400 million euros to the PIX Europe photonic-chip project, with a new TNO fab in Eindhoven, the BBC reported on 18 November 2026. Each fast lane on a photonic module still needs a dc blocking capacitor, and Walsin Technology (Walsin) lists 72 at 100 nF in 0201 and 0402. Venatech is the authorised Walsin distributor in Hong Kong.


Photonic integrated circuits move data with light, but the boards around them are ordinary high-speed electronics: SerDes lanes, driver and receiver chips, bias networks and a lot of small capacitors. This note is for engineers in the Netherlands who design those boards and for the buyers who source them. The news says nothing about any capacitor supplier, and we make no claim about anyone’s bill of materials. What we add is a measured count. On 20 November 2026 we parsed Walsin’s MLCC export (Venatech_MLCC_Upload_01.xlsx onward) for 100 nF parts in the two cases that fit next to a high-speed connector, and checked them against our own shelf.

What did the EU announce for photonic chips in the Netherlands?

Four hundred million euros, and a new fab in Eindhoven. According to the BBC, as republished by Yahoo Finance on 18 November 2026, the EU has committed 400 million euros to PIX Europe, and TNO is building a 10,000 square metre factory in Eindhoven to make six-inch indium phosphide wafers, due to open fully in 2030.

Current production uses four-inch wafers, the report notes, and the Eindhoven line is planned as a foundry making chips to order. Data centres, lidar sensors, medical scanners and 6G links are the applications the report lists. A day earlier, on 17 November 2026, the European Commission said it has approved more than 20 state aid decisions for first-of-a-kind semiconductor facilities, unlocking more than 33 billion euros of public and private investment. For a Dutch module maker, the practical effect is more prototype runs, more evaluation boards and more small builds before any volume arrives.

What does a dc blocking capacitor do on a photonic module board?

It passes the signal and stops the DC. A dc blocking capacitor, also called an AC coupling capacitor, sits in series on a high-speed lane so that two chips with different bias levels can share a signal; 100 nF in 0201 or 0402 is a common value next to SerDes and optical driver chips.

On a photonic transceiver or test board, the electrical side runs from a host SerDes to a modulator driver, and from a photodiode receiver back to the host. Each differential pair usually carries one series capacitor per leg, so a single multi-lane module can hold dozens of them. Three properties decide whether a part works. First, the case size: 0201 keeps the pad small, which matters because a large pad adds parasitic capacitance and spoils the impedance of the line. Second, the voltage: the capacitor must stand off the bias difference with margin. Third, DC bias: Class II dielectrics such as X5R and X7R lose part of their capacitance under applied voltage, and small cases lose more. Our note on MLCC DC bias capacitance loss shows how large that effect can be. Always follow the coupling value in your SerDes or driver vendor’s design guide.

How many 100 nF dc blocking capacitors does Walsin list in 0201 and 0402?

Seventy-two. We counted 72 distinct Walsin part numbers at 100 nF in 0201 and 0402: 51 in 0402 and 21 in 0201, across five series, with 36 in X7R and 40 rated 16 V or more.

Cut of the 100 nF, 0201 and 0402 range Part numbers
All 100 nF parts in 0201 and 0402 72
0402 case 51
0201 case 21
X7R (all in 0402) 36
X5R, X6S or X7S 36
Rated 16 V or more 40
General Purpose series 46
AEC-Q200 MT series 12
Soft termination SH and ST series 7

The split matters for photonics. If the board needs the smallest pad, the 21 parts in 0201 are all X5R, X6S or X7S, so the DC-bias check is essential. If the board can take 0402, the 36 X7R parts give a steadier value over temperature. For harsh or mobile uses such as lidar, the 12 AEC-Q200 parts, for example MT15B104K160, add automotive paperwork. Check the datasheet for each series before approval: DC-bias and frequency curves come from Walsin’s datasheet, not from the export. The General Purpose parts sit in WTC_MLCC_General_Purpose.pdf, the MT parts in WTC_MLCC_Automotive_MT.pdf, the MG parts in WTC_MLCC_MG_Series_Cap.pdf and the SH parts in WTC_MLCC_Soft_term_SH.pdf. The MLCC range page links them.

Which 100 nF lines are on the shelf, and which fit a 3.3 V lane?

Nine lines, and most fit. We found nine of the 72 parts on our shelf in Hong Kong (snapshot 9 November 2026): four in 0201 and five in 0402. For a lane biased near 3.3 V, the 16 V and 25 V parts leave margin; the 6.3 V 0201 part is a closer call.

Shelf part Case Dielectric Rated voltage Match / mismatch for a 3.3 V coupling position
0201X104K6R3 0201 X5R 6.3 V Mismatch on margin: check DC-bias loss at 3.3 V
0201X104K160 0201 X5R 16 V Fit: smallest pad, wide voltage margin
0201X104K250 0201 X5R 25 V Fit: smallest pad, widest 0201 margin
0402X104K160 0402 X5R 16 V Fit
0402B104K160 0402 X7R 16 V Fit: steadier over temperature
0402B104K250 0402 X7R 25 V Fit
0402B104K500 0402 X7R 50 V Fit: for higher bias rails
0402B104J100 0402 X7R 10 V Fit, at ±5 % tolerance

Have part numbers to quote? Click any Walsin part number in the table to open its page and add it to your RFQ, or upload your BOM for a quote, or cross your current part in VenaMatch. E-mail sales@venatech.com.hk or call (852) 2628 4777. We confirm availability, date code and lead time on each quote.

The ninth shelf line is 0402X104K250, a 25 V X5R part. Where a design needs an automotive record, each 0402 X7R shelf value has an AEC-Q200 twin in the MT series, such as MT15B104K250 for 0402B104K250. For RF bias networks around a laser or modulator, a C0G part is often preferred; we also counted 78 Walsin C0G parts at 100 pF in 0201 and 0402, three of them on our shelf, including 0402N101J500.

What should a photonics engineer in the Netherlands check before release?

Three checks, quickly. Before releasing a dc blocking capacitor on a photonic board, confirm the effective capacitance at the real bias voltage, the pad and case size against the line impedance, and a second source with the same case, dielectric and voltage.

Effective capacitance comes first because, as the DC-bias curve in each Walsin datasheet shows, a small X5R part at a few volts can fall well below its nominal value, which raises the low-frequency cut-off of the lane. Pad and case come second: moving from 0402 to 0201 often improves signal integrity more than any change of dielectric. The second source comes third, and it is where a cross-reference saves time on a prototype that suddenly turns into a pilot run. For small-case decoupling next to the same chips, our note on data-centre passive components in 0201 to 0603 shows the shelf side. None of this is regulatory advice; export-control and funding-programme questions belong with your compliance team.

How Venatech helps

A capacitor list in, Walsin parts out, differences stated. Venatech Limited, Walsin’s authorised distributor in Hong Kong, runs VenaMatch, which decodes part numbers from 18 manufacturers and crosses 800,000+ parts to Walsin, so a list of coupling capacitors returns Walsin candidates with case, dielectric and voltage spelled out.

Paste your part numbers into the cross-reference tool, or upload the module or test-board BOM and request a quote through the site. The ready-stock snapshot, dated 9 November 2026, lists the lines on our shelf in Hong Kong; other Walsin parts are supplied to order through our authorised channel. We are Hong Kong-based, handle small lots for prototype and pilot builds in the Netherlands, and confirm availability, date code and lead time on every quote. Walsin is our authorised line; Stackpole and Viking are lines we supply.

The short version

The EU has committed 400 million euros to PIX Europe, and TNO is building a six-inch indium phosphide fab in Eindhoven, the BBC reported on 18 November 2026. Photonic modules still rely on electrical high-speed lanes, and each lane needs a dc blocking capacitor. Walsin lists 72 parts at 100 nF in 0201 and 0402; nine are on our shelf in Hong Kong, and most fit a 3.3 V coupling position with voltage to spare.

Send us the coupling and bias capacitors from your module board, and we will return Walsin crosses with every difference marked. Is your 0201 coupling capacitor still 100 nF at its real bias?

Related reading

Last reviewed: 20 November 2026

Sources

Fetched 20 November 2026.

  • BBC, republished by Yahoo Finance, “Europe plans to catch the next computer chip wave”, 18 November 2026: https://finance.yahoo.com/technology/articles/europe-plans-catch-next-computer-000029729.html
  • European Commission, “Commission marks more than 20 investments to boost semiconductor supply”, 17 November 2026: https://digital-strategy.ec.europa.eu/en/news/commission-marks-more-20-investments-boost-semiconductor-supply
  • Walsin MLCC export, Venatech_MLCC_Upload_01.xlsx onward, re-measured 20 November 2026; Venatech ready-stock snapshot dated 9 November 2026.
  • Walsin datasheets WTC_MLCC_General_Purpose.pdf and WTC_MLCC_Automotive_MT.pdf, linked from passivecomponent.com.

Frequently asked questions

<!– wp:rank-math/faq-block {"questions":[{"id":"faq-question-01","title":"What is PIX Europe and why does it matter in the Netherlands?","content":"PIX Europe is an EU photonic-chip project. The BBC reported on 18 November 2026 that the EU has committed 400 million euros to it and that TNO is building a 10,000 square metre factory in Eindhoven for six-inch indium phosphide wafers.","visible":true},{"id":"faq-question-02","title":"What value is a typical dc blocking capacitor on a high-speed lane?","content":"100 nF in 0201 or 0402 is a common choice, but the right value comes from your SerDes or driver vendor's design guide, so follow that first.","visible":true},{"id":"faq-question-03","title":"How many 100 nF Walsin capacitors are there in 0201 and 0402?","content":"We counted 72 distinct part numbers: 51 in 0402 and 21 in 0201, with 36 in X7R and 40 rated 16 V or more.","visible":true},{"id":"faq-question-04","title":"Does DC bias matter for an AC coupling capacitor?","content":"Yes. X5R and X7R parts lose capacitance under applied voltage, and small cases lose more, so check the effective value at your real bias in the datasheet curve.","visible":true},{"id":"faq-question-05","title":"Which 100 nF Walsin parts are on the shelf for buyers in the Netherlands?","content":"Nine lines were on our shelf in Hong Kong in the 9 November 2026 snapshot, including 0201X104K160, 0402B104K160 and 0402B104K500.”,”visible”:true},{“id”:”faq-question-06″,”title”:”Is Venatech an authorised Walsin distributor for the Netherlands?”,”content”:”Venatech Limited is an authorised Walsin distributor in Hong Kong and ships to buyers in the Netherlands in small lots. Stackpole and Viking are lines we supply, not authorised lines.”,”visible”:true}],”listStyle”:””,”titleWrapper”:”h3″,”titleCssClasses”:””,”contentCssClasses”:””,”sizeSlug”:””} –>

What is PIX Europe and why does it matter in the Netherlands?

PIX Europe is an EU photonic-chip project. The BBC reported on 18 November 2026 that the EU has committed 400 million euros to it and that TNO is building a 10,000 square metre factory in Eindhoven for six-inch indium phosphide wafers.

What value is a typical dc blocking capacitor on a high-speed lane?

100 nF in 0201 or 0402 is a common choice, but the right value comes from your SerDes or driver vendor’s design guide, so follow that first.

How many 100 nF Walsin capacitors are there in 0201 and 0402?

We counted 72 distinct part numbers: 51 in 0402 and 21 in 0201, with 36 in X7R and 40 rated 16 V or more.

Does DC bias matter for an AC coupling capacitor?

Yes. X5R and X7R parts lose capacitance under applied voltage, and small cases lose more, so check the effective value at your real bias in the datasheet curve.

Which 100 nF Walsin parts are on the shelf for buyers in the Netherlands?

Nine lines were on our shelf in Hong Kong in the 9 November 2026 snapshot, including 0201X104K160, 0402B104K160 and 0402B104K500.

Is Venatech an authorised Walsin distributor for the Netherlands?

Venatech Limited is an authorised Walsin distributor in Hong Kong and ships to buyers in the Netherlands in small lots. Stackpole and Viking are lines we supply, not authorised lines.


Share This, Choose Your Platform!